Jump to content
Ultimate Subaru Message Board

Leaderboard

Popular Content

Showing content with the highest reputation on 02/09/20 in all areas

  1. Yards take anything. If someone is picking it up they’ll take it free or charge a few dollars depending how far and current rates. Scrap rates are so low its unlikely to get paid unless you’re lucky. it’ll be chump change even if you’re paid.
    1 point
  2. Just throwing this out there, but looking at the head gasket they sent, it almost looks to me like the hole for the oil galley you guys mentioned where that oem type o-ring goes, the head gasket itself is either made of copper there or it has a special coating for that galley alone. It appears orange/copper colored (bottom left in the pic). Am I correct about that, or looking at the diagram wrong? Perhaps they made it that way to relieve this issue with the rubber o-rings? It is #11 in the OEM diagram. And I believe the intake gaskets in this kit are stamped metal with a coating from what I can tell. Made of the same material as the exhaust gaskets on the head.
    1 point
  3. Jason from NC just made off with a mess of stuff. He didn’t mind the drive , was happy with his take , and didn’t mind helping move stuff out and back in. It was a fun enough kind of day. Anytime I can have a buddy there and going through boxes and stuff it’s a bit of a thrill. So much cool stuff ! Still have fenders , couple of 1600’s one early , one widecase internal water ATK rebuild in crate. Have s/r first 4WD trannies , rear diffs , couple of front bars A style I guess they are. Also steel wheels brand new or super close to new. They were NOS we bought in 2007. There are rear skirts there too - brand new , ‘cause who would remove one ? These weld in place. Hold the tail lights and license plate , that piece. There are stage one sedan and I think coupe too. Brat and 4WD wagon FRONT VALANCES (2) used and one miracle NOS that I hunted for years and finally scored. Some bumpers or metal center beams , new and used. The brand new white flat spoke Made by Jackman for Subaru Of America 13” wheels WITH THEIR CENTERCAPS. Open large wallet please. New in their boxes. Going to need a little session there to straighten up and reassess what’s left for the smaller stuff like interior plastic and exterior trim , lights , etc. Milford CT exit 35 off I-95 , easy to reach. Hotels right next to the storage place if you need one. Cheaper hotels about a mile away. Drive over and you’ll be happy. I appreciate it and reciprocate with discounts. Typical - J offers xxx and I said give me xx. He made a hell of an effort. And he was smart and beat you guys. But plenty left ! 2020 I have to get out of this large , expensive storage hole. Help me out !
    1 point
×
×
  • Create New...