Jump to content
Registrations ×
Ultimate Subaru Message Board
Registrations

ivans imports

Members
 View Profile  See their activity

  • Posts

    2964

  • Joined

  • Last visited

  • Days Won

    10

 Content Type 

Everything posted by ivans imports

  1. ivans imports
    99-01 legacy / impreza
  2. ivans imports
    Check thrust bearings for play
  3. ivans imports
    The heads warp from center out mostly on middle were ex is they were trying to prevent this. The ex part of head gets hotter and more likely to come loose
  4. ivans imports
    Found out this cool swap was able to use Ea 81 head studs in my 1.2 justy fit perfect and was way better to line up gasket and head. Was room for the 17 mm nuts and I think it will help prevent headgasket failure on turbo justy. Also at same time opened up chamber in head to drop ratio. Works good no more ping at 7 psi
  5. ivans imports
    Fit 35's onto the buggy gives me 17.5 inch's ground clearance and tires are 34 inch's apart
  6. ivans imports
    head gaskets
  7. ivans imports
    One small note we remove the soiliniod and valves from awd and run direct line press to it give me locked awd replace all of it with one small tube.
  8. ivans imports
    I use a tiny bit of vasoline or light grease allows it to come off without tearing
  9. ivans imports
    Check main engine ground on intake and power supply on bottom side of under hood fuse box also cam senser
  10. ivans imports
    whoops on newer on old one is just above heater coolant valve
  11. ivans imports
    3 inch from blower motor
  12. ivans imports
    conti belt junk to hard of rubber oem or gates
  13. ivans imports
    +1 4eat love that trans for offroader
  14. ivans imports
    people always call my buggy a side by side drives me nuts[ it's a Subaru people ] anyway get one made want to see it I think the justy running gear's are the lightest
  15. ivans imports
    Change the blower resistor is next to fan held in with 2 screws and has 4 wire plugin
  16. ivans imports
    I used 98 outback struts all the way round had to also use the rear trailing arm front holding bracket. The rear strut mount holes had to be sloted slightly gave me a good 2 inch. I also added ej22turbo front x member / engine and a high low 5 speed just for fun and twin Ebrakes on for each side
  17. ivans imports
    I live a cell phone free life so no ability to post pic's matt did put one of the 80 brat with 16's on this thread
  18. ivans imports
    head gaskets
  19. ivans imports
    Headgasket's have 4 booked next week all same rads do not go bad often but headgaskets do every day
  20. ivans imports
    The trick to the rails is the have to be together when you put the middle shaft thru then can put 2nd shaft in then snaprings and pin a bit of sticky grease will keep ball's / detents in place
  21. ivans imports
    Install a 1/4 inch washer between the reverse idler and case on front side of gear will prevent reverse kickout
  22. ivans imports
    I have a 77 wagon with only 22000 kms for parts will look at the dr rubbers
  23. ivans imports
    had this on forester other day a new sender unit fixed it
  24. ivans imports
    all summer driving brat around no problems gets looks like crazy loving the 16's
  25. ivans imports
    Check wire harness at bottom side of fuse box for corroded wires
×
×
  • Create New...