Handtool

This is the way.

Looks like just because it doesn't list the part as "discontinued" doesn't mean its available.

Any chance your talking about 303 aerospace protectant? This stuff works well on the outside trim plastic and great on tires.

Vice grip chain clamp. I use a piece of old alternator belt to protect the pulley. Works well on cam pulleys also.

Use it as a template to cut a replacement of indoor/outdoor carpet from home depot or some such place.

Probably because with stock forum settings, your original post is the last one on page 1.

It's been done. Here's the guys website, not much info on the swap but it does give a email address if you want to find out more on houw he did it. Judging from his list of mods he's probably a member here. http://www.webspawner.com/users/bratman2/

Nice. How much clearance between the tire and the strut in the rear?

Having you tried jacking up the front of tranny an inch or two? I do this and a lot of cussing and eventually they slide together like they were made to.

All top end, or did you put it in the oil and gas as well?

Hood scoops started in '97. Any hood from a '97 to '99 Outback, GT or SUS will have a scoop and should bolt right up to your '95.

I'm guilty, my car right before I bought my white '86 GL wagon some 12 years ago was a '69 squareback. It was white too.

A bad crankshaft sensor caused a nostart condition after short trips on my '95 legacy with the same 2.2. They are very easy to replace and cost about 25$ new from 1stsubaruparts.com or very cheap to free from your local yard.

Thanks for the suggestion but I'm looking for info on how the rear door speaker grill mounts to the door card of a '95-'99 legacy or outback.

Right, that's where mine are too. They don't do much so I'd like to add some to the rear doors as well. I believe both you guys have gen 1 Legacys? The grills would be specific to the gen 2 legacy and outback, '95-'99. Has anybody swapped out their speakers lately?