Scott in Bellingham

I would drop the tranny back a few inches, you dont have to drop it all the way out, thats how I did my EA82 clutch with 2" blocks on the engine

thanks guys , Ill try to get one local Ill try that sears one first, another ?? whats the difference between the older stub style and the newer male type , do inner parts interchange? can you put newer axles into older diffs with the stub removed or??

rear diff stub shaft socket, what is it and what size?? I got the brocken one off with a 8mm box wrench but the good ones down in a hole, what tool do I need cause I need to go buy one, thanks Scott

heres mine

donut spares steel are thinner then regular rims and the inner bead has no bead lock bump they are smooth

out past Monroe a bit

Chris where are you last time you pulled me out and took some nice video

My Nephew went in the ditch the other day my AAA Plus got him out , the farmers tractor just spun on the road, the tow truck that came used 2 winches front and rear, there truck kept slidding, at one point the driver said " looks like we will need a bigger truck" then it finally came out , I got the AAA Plus back in July when my engine gave in tacoma

:banana: I Didnt do much shopping around looked at Laows they had one 155 btu for $370 a orangeish one, looked at a local Hardware store and got the one ine the picture its 115 BTUs cost $330 its a multi fuel burns kerosine, diesel and Jet fuel , buurns .89 gal per hour used it a couple days now burnt up 5 gals kerosine and 1 gal diesel, I think Im going to burn #2 diesel as it smells better and cost less , I wouldnt have worked out there without it , got a tranny swapped in my white offroader ardvark soobie

Yes but who needs a dash

Yes Sorry about your granny Im going to start on it as soon as I get the diff fixed in my white car, I got the tranny all in

I prefer white, like the contrast with the tire

my 90 legacy with oversize studded snowtires goes anywhere, but I did need to buy this for the shop

good, looks like Chads car is back running

EJ 2.2 have all the parts, went out today and bought a shop haeter that will help as my shop is a Ice cube right now

engine EJ and all the goodies to make run

Would like to get my old red car going again, this ones going to need a engine would like some help, I think Ill go buy a heater tomarrow as its freezing out, would like to take it to Reiter in a couple mos

Jeff can we do this one a week or so later? I would like to have this ready

should be fine if done properly

heres mine

the 4 bolt plate at the front with the rubber mount on top sits basically flat, you can raise the front another 1" without any issues, lets see this buggy your building, start a build thread in the offroad section, what size ATV tires you looking to run??

these will allow for the old VW pattern rims

I have another set of those 390s

where?

temp up then down, sounds like the Thermostat sticky, then it releases, I prefer the best thermostat when it comes to a Subaru