peejay

I'm not sure if I could get one of those in Australia. I know I can't get an XT6 flywheel.

Hi I've got an EJ20G connected to an AWD RX turbo box, using the EA82T clutch and flywheel, but the clutch needs replacing now and it would be nice to get something a bit stronger. Is it possible to use, say an EJ22 clutch and flywheel, in the above setup? This is an offroad beast so I'm not going to hammer the poor thing (much) so I don't need a hydrolic clutch or anything serious lke that. Just looking for a cheap upgrade while it is all apart.

Thankyou, that was the one I was after! Yeah, EJ20 needs an adapter plate to mate with an EA gearbox. It's not too hard to make. There used to be a section in the Ausubaru tech manual on how to do it, I assume it will be back soon. EJ20 fits in an L series no dramas. The only thing I had to do was grind the locating stubs off the engine mounts.

My old EA82T got dunked a bit too deep and no longer runs.... Those diagrams are the newer 4 pin type for the MPFI engine. The one I need is the older one. Thanks anyway:)

Hi all, I'm on the middle of an EJ20T conversion for my RX turbo and I need a pinout for the old EA82T computer. It is the 3 plug type. There was one on the Ausubaru site before the webhost went bust but it's not there now!! GRRRR!!! Any help will be greatly appreciated!!!!!