Search the Community
Showing results for tags '5spd'.
Found 7 results
-
I have a 1980 BRAT with the stock EA71 engine and 4spd trans with stock carb. For now I am looking at just swapping to a EA82 d/r 5 speed an rear diff someday im looking to swap to an EJ22 but I can't find information on if that will even work in my year I am only seeing EJ swaps in 2nd gen BRATs The main thing I am looking for currently is will a EA82 d/r 5 speed fit the engine or will I need adapter plates and different bell housings and what am i looking at for swapping in the rear EA82 diff or should I buy a newer BRAT if I want to change things -
My son bought a stock 92 Justy with 5spd, 4wd and MPFI. We put a new Cat on it and it seems to run fine. We are only getting 31mpg at 55-60mph. We though it should get more in the range of 38-40mpg. Any ideas? -
Ok so I am considering putting a five speed in my wagon but I have no knowledge whatsoever about transmissions so I have quite a few concerns. 1. Is it even possible to put a 5 speed in an EA81 with Dual Range? 2. Will I have to alter my clutch since it is a different trans? 3. THE BIG QUESTION! How much would it cost (assuming I put it in myself) If everything else pans out this could be the defining factor as i am on a strict budget. 4. Anything else that I should know assuming one can even install a 5 speed in an 84 Wagon Thanks all! -
I just want some opinions here, my concern is through the roof. I am considering taking my 1990 Loyale wagon on a trip from Portland, Oregon to Gallipolis, Ohio, which is on the eastern side of the state. The trip is about 2600 miles, beginning on I-84, then moving onto I-80 and I-74. I'm a stranger to drives this far but if I do it, i'm not worried about lack of driving skill or anything like that. I'd maybe cruise a bit less than 500 miles a day until i got there. Who knows. What I AM worried about is ye olde ea82. Its a tough old gal, but it has given me trouble here and there, no surprises. I have a bit of an oil leak on the passenger side cam tower, which became pretty noticeable after cleaning the block. It's not enough so that I need to dump more oil in, in fact, I haven't noticed any oil loss whatsoever. What DOES go down the drain is some coolant, and I dont really know where it goes. Its not an absurd amount but, like i say, noticeable. The car drives like a champ for what it is, a yellow bellied ea82. However, I would kinda be up spoob creek with half a paddle if it blew up on the drive. I know my way around the engine bay no doubt, but thats not gonna save me if i throw a rod bearing or really cream the cam tower/head. Does anyone have experience with a trip like this in a "seasoned" ea82, or some insight they can give me? I would appreciate it greatly. I dont have much cash to save myself in the event of a mass failure. Is it worth trying? Car is a '90 Loyale wagon, optional 4wd, 5spd tranny. Thanks in advance guys. The car has been running pretty solid lately, it has had an electrical problem before but its fixed now. If spoob hits the fan, what kind of costs(jagged, rough estimates) can i expect to get this thing rebuilt? Any parts you see as impending doom-bringers? -
Hey everyone, I'm new here. I decided to join because I am looking into getting a 88 GL Wagon from a man my dad works with. It's the 1.8 (TBI?) coupled to a 5 speed with dual range 4wd, AC, power windows and locks, and silver in color. I might be trading a snowmobile for it otherwise I more than likely will be selling my current car (94 Saturn SL1) and then buying the GL. Anyways, the man who owns it has put a lot of new things into it over the past few years main things being the clutch and motor itself. It has some bubbling paint around where the windshield meets the bodywork. There's also some rust around the rear wheel wells and behind the rear wheels, however the underside of the car looks pretty clean still. I took it for a test drive and it seems to drive okay, it fired right up and was smooth but the clutch pedal had little feel to it and was mushy. Everything else seems clean and functioning. The only things that need work mechanically (to my knowledge) is one side needs new wheel bearings and there is a fuel pressure regulator or something on the gas tank that leaks. With this information that I have provided what is your opinions on it? Is there any red flags or anything that I should be aware of when hopefully purchasing it? Thanks guys!
-
Hello, I have a 2002 Legacy L Wagon 5spd with 195k on it and it's in great shape, runs strong and I love it. I have put many hours into this car mostly in preventative maintenance (keeping the rust away is yearly task up here in SaltLand!). But anyway... my issue: A month or so ago I was pulling into a camping spot in some slightly off road conditions (which I do not normally do, I know it's AWD, but it's not a Jeep!). The place I was pulling into had shallow ruts and it was a very tight turn, and I had the steering wheel cranked all the way to the right and attempted to cross over the ruts and she stalled out because the front bumper cover hit a rock and I was being easy on the throttle. So, I was going to change my angle of approach and I backed up and tried again, and again, with the wheel pinned to the right, she shuttered, bucked and stalled out (remember, it's a manual transmission and I wasn't hammering the throttle). So, I then gave up on this way into the camp site and when I went to take off in first gear there was like this crunch, crunch sound coming from the front end. It was unmistakably a metal sound, so I thought maybe I was hitting a rock, so I got out of the car and looked under it to look for obstructions; and there was none. So I just shrugged my shoulders and continued on down the road. I started hearing like a "clack, clack" sound when I would let off on the throttle, and I thought maybe I broke a tooth on a CV joint or something. Later I noticed a whining when I got up to about 30 miles an hour, mostly when I let off on the throttle. It seems to go away when I give it throttle or am over 40mph. I showed a mechanic friend of mine the problem and he said not to worry about it... so I haven't been... UNTIL THE OTHER DAY! .... I was backing down a friend's dirt driveway and maybe going a little fast for being in reverse, but all of a sudden it just sounded like someone dropped a bag of ball bearings into my gearbox! It didn't entirely bind up tight (there were no skid marks) but it slowed way down, and as soon as this happened I threw the clutch in.... When I proceeded to back up, it seemed find again... It's been a week now, and it's still going, but has the whining and clicking sounds like it has since I broke whatever I broke. I will not be gunning it in reverse again! My question: what did I break, how can I fix it and how much longer do I maybe have until I will be without a ride? Has anybody else ever heard of anything like this or experienced anything like it? Any insight or direction would be appreciated. Thanks! Chris -
I have a 91 legacy and it keeps popping out of 4th gear while driving so I figure with 327k on it it's time for a new tranny. It is a 5 spd AWD. I am wondering which trannys will fit. I would like to get one out of a newer car with less miles so 90 to 94 will probably have too many miles. I was told after 94 something about the exhaust hangers are differant which doesn't bother me, I just want to make sure the wiring and componants are the same. And does anyone know for sure what the final drive gear is 390 or 411? Thanks.
