Jump to content
Ultimate Subaru Message Board

Search the Community

Showing results for tags 'XT Coupe'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Welcome to the USMB!
    • Meet n' Greet. Your USMB Welcome Center
    • Members Rides
  • Older Generations of Subaru's 1960-1994 Except Legacy and Impreza
    • Historic Subaru Forum: 50's thru 70's
    • Old Gen.: 80's GL/DL/XT/Loyales...
  • Newer Generations of Subaru discussion
    • 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX
    • BRZ and its Sister the Scion FRS/Toyota GT86
    • Crosstrek "XV"
  • Marketplace
    • Ultimate Subaru Store
    • Products for your Subaru
  • Upgrading and Racing Discussion
    • Performance Tech Forums
    • Subaru Modifications
    • Subaru MotorSports
  • Ultimate Subaru Repair Manual-The Knowledge Base of USMB. Complied posts and writeups to common problems and projects.
    • Submit a Tip or Mod to the USRM
    • Product Links and References
    • The old Ultimate Subaru Repair Manual
    • Engine
    • Engine Electrical
    • Transmission, Axle, and Brakes
    • Heating and Cooling systems
    • Body Exterior
    • Interior / Body Electrical
    • Stereo tips and tricks
    • Offroad Modifications
    • Suspension and Steering
  • Off Topic Areas
    • Shop Talk
    • Alternative Vehicles (non soob)

Product Groups

  • Member Accounts
  • Ultimate Subaru Decals
  • Subaru Parts
    • Weber Carbs and Parts
    • Used Subaru Parts

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Full Real Name


Occupation


Ezboard Name


Referral


Biography


Vehicles

Found 2 results

  1. Hey everyone, I've got some new problems with my 87 GL10 Turbo XT. I'm hoping you all can help me out again. I pulled the coolant passage off the back of the intake manifold to replace the gaskets and the thermo vacuum valve as they were leaking coolant. To get it out without pulling the entire manifold I had to remove the turbocharger, distributor, knock sensor, and the throttle cable bracket on the bell housing. I just recently got it all back together and after some issues timing it (since I removed the disty) we finally got it to time at 25 degrees BTDC. Now however it tries to idle at 3000 rpm and heats up really fast and overheats despite my upgraded dual core cooling system. We haven't done tons of troubleshooting yet, just looking for things to try while I do so. It ran like a dream before I took it apart for the leak. Any suggestions? Thanks in advance.
  2. Subaru XT Coupe : Found someone with a creative licence who redrew this Vortex Ute : Add : Does anybody know who drew this ? And this is my take on it : Drew up another view of it : As far as doing the 'mod' for this I think it would be relatively easy : Remove the back seats, boot & turn it into a tailgate ( Optional to make a hard cover version as shown ). Cut the roof just behind the B pillar, then slide the rear window forward until it meets the back of B pillar + cut the side windows down to fit. Knock up some inner panels for the tray, then form up some ‘tube rails’ to go round the tray edges, turning up & over with a ‘roll bar’ somewhere near the B pillar, paint it red, and lastly put a few spotties on it. Bob’s your Uncle … Also finished drawing up the rear end opening : A few notes on this : Hinge for tail gate would need to be reinforced from behind & some sort of support to stop it from dropping down too far. The bar around the edge of tray could be 2x2" square box section shaped / rolled to suit. A smaller section used as spacers / connectors to frame ( I'd leave enough room to get your fingers in gap ) Removable hard top & latches not shown for clarity ... If anyone one wants to build it, let me know& will do some more accurate sketches ... P.S. - Mr Willy has a old shell that he's going to chop up, might get to see what it looks like ... Cheers, Bantum ...
×
×
  • Create New...