Search the Community
Showing results for tags 'antenna'.
-
G'day from Singleton Australia ! Here's how I did my 80ch UHF radio install. Antenna mounted on rollbar. Close up Old console shot with cassette deck I ripped out to put the UHF in. Removed the whole console to work on it Cassette deck out, look what was underneath.. original radio stuff. The original am/fm hole was hogged out with a hacksaw to take the tape deck. Needed to remove 2 plastic ridges to mount the UHF bracket flush with the internal console housing Had some stainless bolts the right diameter in the shed. They're too long but I cut them down to size. Used a dremel to slot the upper plastic ledge. The plan is to inteference fit the bolt heads under it. Checking slots for bolt diameter clearance here. Bolts measured for cutting UHF radio mounting bracket measured and drilled The bolt heads are an interference fit. That means the heads are taller than the slot clearance. Old plastic is brittle unless you heat it first. Wifey's hairdryer is alot more forgiving than my heat gun so I used that instead Bolts mounted and gently tapped home with a flat blade screwdriver and the palm of my hand for a hammer 4wds are subject to heaps of vibration so spring washers are a must do item Bracket bolted into place UHF head unit bolted up to bracket Here's what the console looks like from the front. I will manufacture a face plate later to make it look pretty Mounting position for the handpiece is on the front of the ashtray And bolted up Looks like this from the front Fuse holder mounted Console installed back in the car. Thinking I'll use the old volume and tone control holes for power window switches later on All systems go ! Job done and works like a ripper ! Cheers, Knucklehead.