Search the Community
Showing results for tags 'keyless'.
Found 3 results
-
2005 Outback 2.5i I have been having intermittent issues with Keyless Entry not working. I've replaced battery in fob, cleaned terminals, cleaned body ground, etc. Battery is good. Also, one day, recently, I also had an issue where I turned key and nothing.....no click, no starter turn over, no dimming of overhead or head lights as key hit start position. Starter has been replaced once (although still possible it could have a flat spot). I have to suspect the two may be related. Still think it could be a bad ground, but as mentioned, normally will still start except for that one time. Seems like after it starts the entry will work for a bit, but then returns to dead. I'm uncertain as to the function of the security relay (located near glovebox), but it appears that may effect the grounding to the starter, so a keyless entry issue may compound into a starting issue....thoughts? With all that said, my suspects in order of concern (and likely cost) are: Wiring Keyless Entry Module Security Relay Starter Relay Body Integrated Unit Engine Control Module *unlikely) Unless there are other ideas, I'd like to start at the Keyless Entry Module. I'm having trouble understanding the function of each of the 8 wires in the i96 connector. From diagrams I can only really isolate three. Anyone have any ideas what the other wires do? 1-? 2-? 3-YG to A9 of BIU (uncertain of function) 4-LR-to FB-10 M/B Fuse #8 (I assume this is 12V constant) 5-? 6-? 7-BY-to ground and A21 of BIU (assume this is the constant GROUND) 8-? Any other possible advice? This is my wife's car and with this intermittent issue, I don't want her to drive it and end up stranded in the coming winter chill. Thanks! -
The alarm will go off occasionally when not set on. Vibrations sometimes will do it --like on a ferry. Other times its sitting in my driveway at night. I replaced my car battery, as it was getting old --that didn't help. Any ideas? I'd prefer to fix myself. At minimum, I want the keyless remote to keep working. It would be nice to get the alarm reliable again, but I'd settle for disabling just the alarm system or the sound. I did find some data in my glove box. Security System Upgrade Legacy H7110AS600 and H7110AS400 Remote Keyless Entry System It does say that there is a shock sensor. If I can find it, maybe there is an adjustment. Next time it goes off, I'll see how many chirps so I can check what set it off. 1998 Subaru Legacy Outback Wagon Left it in valet mode last night. Alarm went off two or three times during the night. I'll see how easy it is to just disconnect the siren until I can fix the system. -
Has anyone on hear done any work with the Subaru key less entry systems? I bought a 98' Impreza awhile back and it came with a key fob, but didn't work.. put a new battery in the key fob still nothing, looked under the dash to make sure everything was hooked up, all checked out okay... Never messed around with any of these but would like to get it working again, so if anyone can point me in the right direction I would appreciate it!....another thing my 01 legacy had the same thing and when I locked the doors manually and shut it it would do the "beep" sound, My Impreza does not though...Don't know if that helps any....and It is a Subaru OEM dealer installed key less entry system