Search the Community
Showing results for tags 'mount'.
-
1984 Subaru, I want to be able to tow this one. Should I connect the tow bar to the tie down points, (safe, secure) or, to the bumper (convenient, iffy) ?
-
It's been a long time since I've posted. Ahhh, this feels good. Anyways, my diff support bushings are toast. I'm looking into options to replace them. Does anyone have any advice on specific products or procedures to do the job? If I have to drop the differential, I'd like to do the diff mount bushings too, pending time and money. Here is what I think can be installed; please correct me if I'm wrong: Support bushings (ones on the outrigger near the outside edge of the vehicle): Whiteline W91379 and for the diff mount bushings (ones at the rear of the diff): Whiteline W91380 Do these look like the correct parts? Thanks for verifying. Here is a vid of a similar procedure that I have found. This guy pulled the entire support bracket out to do the job. Is this how you guys have done it or is there an easier way? Thanks, SK
- 8 replies
-
- Diff
- Differential
- (and 6 more)
-
How to Store Flat Tire. 1. Screw the shaft into the floor though the slit in the mat covering the trunk floor ( or luggage space floor). Insert a screwdriver in the hole present in the shaft end and rotate the shaft in a clockwise direction until it is tight. (Make sure the mat is not caught.) 2. Pass the shaft through any one of the lug holes in the wheel and tighten the wheel down with the holder until it is fully secure.