Search the Community
Showing results for tags 'wires'.
Found 5 results
-
Hi guys, I am trying to do a tune-up on my 98 Legacy outback & ordered a wireset & coil from Rock Auto months ago. Finally went to put it in & it was all wrong. I thought it must be a mistake so went down to Napa to get the correct set & the one the pulled up is the same as Rock Auto. Now this is obviously wrong - the coil on my 98 has the female sockets for the plug wires & even the bolt pattern is different than the one I got on Rock Auto so it wasn't just a coil swap. My ID plate says 98' EJ25D which seems correct... Any ideas? ... What gives?
-
Anyone have a fix for this issue that these seem to have? My passenger side I wiggle the wires a little and it comes on the drivers side goes out. I just got the car but I had this issue on my 01 legacy gt. I'm going to try contact cleaner and that gel stuff they try to sell you at the store. -
Recently bought a 93 Legacy wagon off Craigslist for my father to commute to work out of town. It runs good and is used to commute 250mi's a week (highway drive 125mi there & 125mi back). I check it out every weekend when he gets back. THE MAIN issue is it backfires thru intake at startup & the idle is high, only when engine is cold! After it warms up it runs better & idles fine. It had the Bosch 4 prong platinum spark plugs, runs better with copper NGK's, but still backfiring. I cleaned the PVC vavle, MAF sensor, IACV, & throttle body also. Had the exhaust checked out & they replaced 1 of the cats but not sure if they really checked EVERYTHING out. Previous owner had replaced the plugs/wires & air filter. I've researched this & came across a few possibilities but the car runs fine once warmed up. coolant temp sensor could be failing-dumping too much fuel at warm up. Timing belt could have jumped a tooth. Exhaust leak near the head or at the Y-pipe allowing air in & then closing when warmed up. Low or uneven compression. These are some of the problems that I read can cause a backfire but the car runs really nice once warmed up. Another issue is the speedo doesn't work. Check engine light is on for Vehicle Speed Sensor. And the POWER light for the trans blinks when you turn the key on. I figure that the tranny Control Unit senses the VSS & is why power light blinks. So does this mean the Tranny is in a "SAFE MODE" not performing at its best because the computer sensed a problem? It feels like it could have more acceleration & performance is what im getting at. Any helpful suggestions, comments, questions or information is highly appreciated! THANKS. -
I have noticed some missing in my 2006 WRX lately and, even though miles are low, according the the 'time' side of the schedule, it may need new plugs so, I ordered some. any hints, tips or warnings for pulling the wire boots, changing the plugs, access, etc. appreciated. anything else nearby I should inspect or change? thanx guys -
I've been starting my '00 Legacy with just the ignition switch for the last few days after having it stolen and I'm just about to put in a new ignition. I'm a bit confused as to what the wires coming from the ignition barrel itself are for and where they plug in. Is one the steering lock maybe? Can someone help me out? Cheers!
