Dickensheets Posted October 14, 2009 Share Posted October 14, 2009 I picked up a block heater for my "new" 2007 Forrester. I haven't put it in yet, it's too cold out lol! Question: From the top looking down it looks like I may have to drop the exhaust manifold a tiny bit. Can anyone confirm or deny this? Ryan Quote Link to comment Share on other sites More sharing options...
valvestem Posted October 14, 2009 Share Posted October 14, 2009 Here's a link to help I hope, I gues it depends on model/year on the exhaust manifold: http://www.subaruforester.org/vbulletin/f85/block-heater-27749/ scroll down for the message with the PDF's attached. Quote Link to comment Share on other sites More sharing options...
Dickensheets Posted October 14, 2009 Author Share Posted October 14, 2009 Ok thanks for that. I will see when wifey gets home. Quote Link to comment Share on other sites More sharing options...
porcupine73 Posted October 15, 2009 Share Posted October 15, 2009 (edited) Not sure on that setup if you need to drop the xhast manifold. I did install one of these heaters on my '96 and it was pretty easy. Hardest part was getting the plug out. It took a 14mm hex thing. I used an impact wrench and beat it out. goes in here-> Edited October 19, 2009 by porcupine73 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.