robm Posted November 9, 2009 Share Posted November 9, 2009 My friend's 95 Legacy needs a new fuel filter. Apparently, it is in/under/near the tank, and impossible to get to without dropping the tank? Is this correct, or is there a work-around known only to the elite Subaholics that frequent this forum? Thanks. Rob. Link to comment Share on other sites More sharing options...
bheinen74 Posted November 9, 2009 Share Posted November 9, 2009 (edited) who told you this? look under the hood, over near the driver side firewall. should be right there. you gotta pull the engine out and take out the steering wheel to change it though..... Just Kidding. it should be easy to change, hard part will be pulling off the several hoses which they make hose pliers for that type of thing to twist and grab to pull off. its a good idea to release the pressure from the pump, to do this, disconnect the connector to the fuel pump., start car it will run about a few seconds with no pressure til it dies. then there pressure is gone Edited November 9, 2009 by bheinen74 Link to comment Share on other sites More sharing options...
robm Posted November 9, 2009 Author Share Posted November 9, 2009 (edited) Looking at on-line parts, a "Canister Fuel Filter next to Fuel Pump In-Tank" is offered, as well as a black tin can with a couple of pipes sticking out of it. It seems there are 2 on this model. Rob. Edited November 9, 2009 by robm Link to comment Share on other sites More sharing options...
Olnick Posted November 9, 2009 Share Posted November 9, 2009 No need to drop the tank. There's an access plate on top of the tank, you get to it from behind the rear seat. Link to comment Share on other sites More sharing options...
Fairtax4me Posted November 9, 2009 Share Posted November 9, 2009 The "canister filter' is probably the pump strainer, and there is really not much need to replace that unless you plan to have the pump out for replacement. It's not a fine filter like the one under the hood. It's there for bigger stuff like larger sediment. Link to comment Share on other sites More sharing options...
robm Posted November 9, 2009 Author Share Posted November 9, 2009 Endwrench says that early Legacies had only the underhood filter, and the in-tank filter came in about 2006. However, the parts place shows the in-tank filter for 1994 onwards. I suspect this is an "only in Canada" thing. The Canadian parts house show it, but not the US ones. It seems to be part of the fuel pump assembly. Any good way to get at this device? Rob. Link to comment Share on other sites More sharing options...
86subaru Posted November 9, 2009 Share Posted November 9, 2009 use a pair of pliers and a rag , maybe even safety glasses , will run out , do it outside , on gravel or grass , and of course no smoking, spray the fuel line with lube, around the fuel filter, Link to comment Share on other sites More sharing options...
frag Posted November 10, 2009 Share Posted November 10, 2009 Endwrench says that early Legacies had only the underhood filter, and the in-tank filter came in about 2006. However, the parts place shows the in-tank filter for 1994 onwards. I suspect this is an "only in Canada" thing. The Canadian parts house show it, but not the US ones. It seems to be part of the fuel pump assembly. Any good way to get at this device? Rob. I've got a canadian 96 and the filter is under the hood right next to the driver's side strut tower. Don't mess withe the fuel tank. Link to comment Share on other sites More sharing options...
robm Posted November 10, 2009 Author Share Posted November 10, 2009 (edited) I should be more clear: the Canadian parts houses show 2 filters, one underhood and one in the tank. An update: The issue is a minor fuel leak from the tank. Their mechanic is suspicious of the on-tank/in-tank filter. I figure it is more likely to be a hose on the pump assembly or on the vapour separator, or corrosion of the tank itself. Their mechanic also claims there is no access port in the car for the pump assembly, which I find hard to believe. I will have a look next time I go over there, the car is only 200 odd klicks away.... Rob. Edited November 10, 2009 by robm Link to comment Share on other sites More sharing options...
Fairtax4me Posted November 11, 2009 Share Posted November 11, 2009 There is an access port. It's under the carpet behind the rear seat. In the trunk on sedans, but either wagon or sedan it is still easily accessible. Link to comment Share on other sites More sharing options...
frag Posted November 11, 2009 Share Posted November 11, 2009 I should be more clear: the Canadian parts houses show 2 filters, one underhood and one in the tank. An update: The issue is a minor fuel leak from the tank. Their mechanic is suspicious of the on-tank/in-tank filter. I figure it is more likely to be a hose on the pump assembly or on the vapour separator, or corrosion of the tank itself. Their mechanic also claims there is no access port in the car for the pump assembly, which I find hard to believe. I will have a look next time I go over there, the car is only 200 odd klicks away.... Rob. A mechanic who does'nt know there is an access trap sould'nt be trusted with your car. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now