Dirk Posted November 10, 2009 Share Posted November 10, 2009 (edited) How do you spot the difference between an EA71/81 with pushrods or hyrdaulic lifters? and what are the benefits of either? Edited November 10, 2009 by Dirk Link to comment Share on other sites More sharing options...
hatchsub Posted November 11, 2009 Share Posted November 11, 2009 Im going to just clarify this a bit. Both the hydraulic and solid lifter motors are pushrod motors. The difference is the lifters themselves. Therefore i dont think there was ever a Hydro EA71. I think they only did that with the EA81s but i could be mistaken. The EA81s with hydro lifters will have a sticker on the valvecover that says "do not adjust valve clearance". Link to comment Share on other sites More sharing options...
Qman Posted November 11, 2009 Share Posted November 11, 2009 I believe the later wide case EA71's were also hydraulic. At least the '85 and later. But, yes, they are all the EA71 and EA81 motors were pushrod motors. Link to comment Share on other sites More sharing options...
hatchsub Posted November 11, 2009 Share Posted November 11, 2009 (edited) I believe the later wide case EA71's were also hydraulic. At least the '85 and later. But, yes, they are all the EA71 and EA81 motors were pushrod motors. For some reason i brainfarted that the EA71 was continued on at the same time as the EA81s (probably cause i have never seen one other than in a junkyard once). Any EA71 wide case motor from 85 on should be a hydro motor then. Edited November 11, 2009 by hatchsub Link to comment Share on other sites More sharing options...
Dirk Posted November 11, 2009 Author Share Posted November 11, 2009 Cool. Thanks guys. And the pro's and con's? Link to comment Share on other sites More sharing options...
hatchsub Posted November 11, 2009 Share Posted November 11, 2009 Cool. Thanks guys. And the pro's and con's? Pros: No adjusting of valves Cons: Valves will "float" at the higher rpms to some extent I also dont think you can use a hydro motor because i think you have a top mounted starter and not a sidemounted one. To use a hydro motor you would have to swap transmissions too. Link to comment Share on other sites More sharing options...
GeneralDisorder Posted November 11, 2009 Share Posted November 11, 2009 I'm not 100% on this, but I beleive the bell-housing's can be swapped between some of the later EA71's with side-starter's and the early one's with top-starters. So, in theory, you could put the top-mount starter bell-housing on the later hydro lifter engine and have a compatible setup. And before someone asks - no, you can't do this with an EA81. The top-mount starter bell-housing won't fit the EA81. GD Link to comment Share on other sites More sharing options...
Dirk Posted November 11, 2009 Author Share Posted November 11, 2009 Thanks, Ill check that out. Iv'e had the transmision out on various occasions so its no dramas if I do need to change it. Link to comment Share on other sites More sharing options...
GeneralDisorder Posted November 11, 2009 Share Posted November 11, 2009 The bell-housing is part of the engine, not the transmission. Or were you talking about swapping the transmission to the side-starter? GD Link to comment Share on other sites More sharing options...
Dirk Posted November 11, 2009 Author Share Posted November 11, 2009 transmition swap. But I seem to recal a mechanic saying something about retro fitting bell housings. I think he had done it but it did require some sort of mod to seal it properly. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now