hatchsub Posted January 18, 2010 Share Posted January 18, 2010 I did it up near the actual valve but now that i have the motor out of the car i cut the pipe off and pulled the pipe thread from the actual spacer. I stuck a quarter in there and impacted the pipe thread nut back on. Will that quarter hold up to exhaust heat? Quote Link to comment Share on other sites More sharing options...
GeneralDisorder Posted January 18, 2010 Share Posted January 18, 2010 Yeah - heat isn't an issue - the quarter should be fine. I usually just remove the threaded portion from the pipe, drop a fender washer in there and weld it in place. GD Quote Link to comment Share on other sites More sharing options...
hatchsub Posted January 18, 2010 Author Share Posted January 18, 2010 Awesome thats what i wanted to hear. Thanks Quote Link to comment Share on other sites More sharing options...
Bucky92 Posted January 18, 2010 Share Posted January 18, 2010 remember.. I cut mine off ..folded and beat the opening over..then welded it shut... Quote Link to comment Share on other sites More sharing options...
hatchsub Posted January 18, 2010 Author Share Posted January 18, 2010 remember.. I cut mine off ..folded and beat the opening over..then welded it shut... Yea i was going to do that until i found out how damn thick those pipes were. I took the lazy way out and just threw a quarter in there lol. Quote Link to comment Share on other sites More sharing options...
ivantruckman Posted January 19, 2010 Share Posted January 19, 2010 cheap repair, only cost you a quarter Quote Link to comment Share on other sites More sharing options...
bheinen74 Posted January 20, 2010 Share Posted January 20, 2010 you can also use the knockouts from a electrical box i believe, even cheaper yet. I have a quarter in mine cause i know it can take the heat. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.