Jump to content
Ultimate Subaru Message Board

Recommended Posts

I took apart a 98 Outback engine 2.5 DOHC to do head gaskets timing belt etc...found this part in the garage left over...not sure if it is from the outback or a different car...

 

...can anyone confirm where this goes if from an Outback?

.

.

 

subiebracket.jpg

Link to comment
Share on other sites

Is that a rubber type backing on that angle? If so it doesn't go near the header which I origionally thought. That vibration damper would suspend a bracket of hydraulic lines or something so they don't go thru a million vibrations.

Edited by Fuzpile
Link to comment
Share on other sites

Bingo

 

Looking again I'm pretty sure that goes on the upper, front AC compressor bolt and holds the far end of the AC belt cover.

 

Oops - yea that's what I meant. Holds that little piece of black plastic that covers the pulley on the AC unit and is held on by one of the long AC compressor bolts. Because I've forgotten the bracket in the past.

Link to comment
Share on other sites

Oops - yea that's what I meant. Holds that little piece of black plastic that covers the pulley on the AC unit and is held on by one of the long AC compressor bolts. Because I've forgotten the bracket in the past.

 

+1

That one's a PITA to put back on as you have to remove an AC bolt. Not hard, just extra work! (Yes, been there/done that!):-\

 

GL,

TD

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...