Jump to content
Ultimate Subaru Message Board

Recommended Posts

I have a 98 Outback Limited with a P1507 code, I just replaced the neutral switch as well as the IAC valve complete. Neither have fixed it. I still get the error code and then the limp mode runs on 2-3 cylinders. I cycle the ignition and it runs OK for anywhere from 30 to 3,000 miles.

 

Prior to these recent repairs I have replaced the following in the last year:

head gasket update

intake gaskets

exhaust flange gaskets

outer valve cover gaskets

inner valve cover gaskets

valve cover bolt seals

rear cam plugs

cam seals

exhaust flange nuts

oil and filter (regularly)

drain plug gasket

coolant

belts

radiator

crankcase breather update

timing belt

tensioner

idlers

water pump

thermostat

clutch

fuel pump and sending unit

alternator

coil

ECU

speed sensor

CV boot right passenger front under Cat

cleaned connections on speedometer

 

Car has 171k on it, doesn't smoke, consumes 1 qt oil every 2k, local ROOPair shop can't figure it out, please help!

Edit/Delete Message

Edited by mustangthegreat
no response
Link to comment
Share on other sites

  • 2 weeks later...
My local Subaru shop found a TSB on bad grounds for this problem for this model, it described cleaning all of the grounds and it appears to have worked.

 

Before this they also replaced the speedometer. Car has a new life now.

 

As I recall there are two main grounds, one on either side of the engine.

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...