brus brother Posted February 8, 2011 Share Posted February 8, 2011 Just tried to wrench out the plugs on 05 OB with 105,000 miles. The very fist one made a very disconcerting creaking and didn't feel right. I stopped and tightened it back up and all seems fine for now. Is there any trick to getting this out safely or has irreparable damage been done by leaving the ORIGINAL plugs in so long! Do these plugs become one with the head after such a long time? Link to comment Share on other sites More sharing options...
Rooster2 Posted February 8, 2011 Share Posted February 8, 2011 I had similar problem, a few years back when I replaced the plugs after buying a used 99 OBW. Pretty sure the plugs and wires were original, with 148K miles on the odo. The wires seemed shrunk wrapped to the ends of the plugs, and the plugs nearly bonded to the heads. I had to rip and tear the plug wires off in order to get a socket to go over the plug. Same result you had, kind of a creaky sound caused by rust and corrosion. I think that is called galling. Once I had a plug break loose, then I would slowly loosen, then tighten, then loosen a few times to finally be able to unscrew the plug. Just take your time, and slowly remove the plug with out torquing the drive handle at an angle. Upon replacement, I used antisieze cream to lube plug tightening, and to prevent galling in the future for plug replacement. Link to comment Share on other sites More sharing options...
Fairtax4me Posted February 8, 2011 Share Posted February 8, 2011 With no anti-seize they can become "sticky" after they've been in there long enough. Kinda like an old rusty bolt. They're probably fine. If you really want, you can shoot a quick shot of WD or PB on the plug after loosening it a turn or two. Link to comment Share on other sites More sharing options...
brus brother Posted February 8, 2011 Author Share Posted February 8, 2011 Thanks for the tips and reassurances. Hold my ankles... I'm going in! Link to comment Share on other sites More sharing options...
davebugs Posted February 8, 2011 Share Posted February 8, 2011 Just take your time. No anti-seize from the factory (stupid!) even though dissimilar metals. I use anti seize and dielectric grease on the tops of the new plugs. Sometimes the plug wire boots can be a pain as well. Link to comment Share on other sites More sharing options...
Olnick Posted February 8, 2011 Share Posted February 8, 2011 Please let us know when you're safely out. We worry, you know. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now