Petersubaru Posted February 14, 2011 Share Posted February 14, 2011 (edited) in this case, with a 2001 OB, but applies to any ball joint.. http://community.discovery.com/eve/forums/a/tpc/f/7501919888/m/24719753201 or youtube "exploding ball joints" Edited February 14, 2011 by Petersubaru Link to comment Share on other sites More sharing options...
shane_h Posted February 14, 2011 Share Posted February 14, 2011 Wow. Just wow. Do you always need to heat them up? I think I need to do this soon for my 86 GL. I've never replaced ball joints before, and now I'm a bit less than eager... Link to comment Share on other sites More sharing options...
Petersubaru Posted February 14, 2011 Author Share Posted February 14, 2011 Wow. Just wow. Do you always need to heat them up? I think I need to do this soon for my 86 GL. I've never replaced ball joints before, and now I'm a bit less than eager... ..on an '86 you don't have to do that.."loosen or remove" completely the nuts on the sway bar attached to the swing arm.."just loosen" the nut on top of the ball joint..."remove" the bolt completely holding the bottom of the ball joint..useing a long steel bar, 4-6ft long pry up on the swing arm to lift the ball joint out of the socket...pb blaster will help.. Link to comment Share on other sites More sharing options...
shane_h Posted February 15, 2011 Share Posted February 15, 2011 ..on an '86 you don't have to do that.."loosen or remove" completely the nuts on the sway bar attached to the swing arm.."just loosen" the nut on top of the ball joint..."remove" the bolt completely holding the bottom of the ball joint..useing a long steel bar, 4-6ft long pry up on the swing arm to lift the ball joint out of the socket...pb blaster will help.. That's a relief. Thanks! It sounds like this procedure is a lot easier on Subarus than it is on other cars. Reason #487 to own a Subie. Link to comment Share on other sites More sharing options...
94Loyale Posted February 15, 2011 Share Posted February 15, 2011 Do yourself a large favor though, soak the pinch bolt for the ball joint ahead of time with PB blaster. They have a habit of breaking, and they are not fun to drill out. Link to comment Share on other sites More sharing options...
Allpar Mod Posted February 15, 2011 Share Posted February 15, 2011 I was warned about ball joints exploding if overheated a long time ago. You definately don't want to be anywhere near one if that happens, and if you are, your medical insurance better be up to date. Link to comment Share on other sites More sharing options...
Fuzpile Posted February 15, 2011 Share Posted February 15, 2011 Many comparisons yet one to gross U. When teeth go bad and are but a Nub and need removal there are different ways. In adult years there was some preparation. That is there were gentle platforms built across other teeth and a clamping sensation. the actual extraction was painless because of numbing and also the extraction was a concentrated exercise between finite points. The dentist didn't actually show me the tool yet i know it was a a puller like a a small bearing puller deal. Went straight and sweet. The alternative was another which again by knumbnense, Worked yet I saw his pliers later/ they were same as some whatevers I had sitting around. The deal is to concentrate with opposing forks of finite reach and just enough force to break the bond. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now