revox Posted May 29, 2011 Share Posted May 29, 2011 A new problem started (no pun intended) yesterday. My car just wouldn't start. No cranking, nothing. All electrical still worked when the key was on. I can hear the starter relay clicking. I tried removing the alarm's kill switch, but it still won't start. A friend pulled the cable off the starter and tested it while I turned the key, and said there's no power to the solenoid wire. Could it be my ignition switch? I'm suspecting that because it seems loose, and the courtesy beep is (and has been since I've had the car) intermittent. Is there anything else I should check before changing the ignition switch? thanks! Link to comment Share on other sites More sharing options...
idosubaru Posted May 29, 2011 Share Posted May 29, 2011 i would verify it's the ignition switch before swapping in another, they're not terrible but sort of a pain. they have to be drilled out. electronics is a weak point for me so not sure how to verify it. Link to comment Share on other sites More sharing options...
MilesFox Posted May 29, 2011 Share Posted May 29, 2011 I vote ignition switch. jump a wire to start the car. Install a pushbutton, or a relay to solve the issue Link to comment Share on other sites More sharing options...
revox Posted May 30, 2011 Author Share Posted May 30, 2011 I vote ignition switch. jump a wire to start the car. Install a pushbutton, or a relay to solve the issue Funny you should mention that. My friend ran a wire from the starter to the inside of the car. He put a cigarette lighter plug on it. To start the car I just turn on the key then put that thing into the socket until the car turns over, then I pull it out. It's SO GHETTO! ..but it's only temporary until I can get the ignition changed. Link to comment Share on other sites More sharing options...
brycarp Posted May 30, 2011 Share Posted May 30, 2011 It's SO GHETTO!I believe the operative word is "pragmatic." Link to comment Share on other sites More sharing options...
idosubaru Posted May 30, 2011 Share Posted May 30, 2011 Funny you should mention that. My friend ran a wire from the starter to the inside of the car. He put a cigarette lighter plug on it. To start the car I just turn on the key then put that thing into the socket until the car turns over, then I pull it out. It's SO GHETTO! ..but it's only temporary until I can get the ignition changed. that's awesome, can you take a picture? (i'm being serious). so you have one wire running to a cigarette lighter and you simply push that lighter into the cigarette receptacle and then turn the key and the car starts? so it's powering the solenoid or....? Link to comment Share on other sites More sharing options...
mdjdc Posted May 30, 2011 Share Posted May 30, 2011 I agree with Gary that changing the entire switch is a pain, but you only have to replace the electrical part. That is held onto the endlof the assebly by one or two small screws. Apain to get to, but not impossible. Go for the replacement and have a good ignition again. Link to comment Share on other sites More sharing options...
revox Posted May 31, 2011 Author Share Posted May 31, 2011 I agree with Gary that changing the entire switch is a pain, but you only have to replace the electrical part. That is held onto the endlof the assebly by one or two small screws. Apain to get to, but not impossible. Go for the replacement and have a good ignition again. is this the part you're talking about? Subaru Ignition Switch Link to comment Share on other sites More sharing options...
mdjdc Posted May 31, 2011 Share Posted May 31, 2011 That is the one. The hardest part is getting the small hold down screws out. You will need a small philips driver to get them out. Good Luck. Link to comment Share on other sites More sharing options...
nipper Posted June 2, 2011 Share Posted June 2, 2011 SO no one has checked the inhibitor switch (or NSS if it is a manual) or tried starting the car in neutral? Link to comment Share on other sites More sharing options...
revox Posted June 2, 2011 Author Share Posted June 2, 2011 SO no one has checked the inhibitor switch (or NSS if it is a manual) or tried starting the car in neutral? I tried starting the car in neutral. No-go. Also, we used a meter to check the wire going to the starter solenoid and there was nothing while turning the key. Link to comment Share on other sites More sharing options...
johnceggleston Posted June 2, 2011 Share Posted June 2, 2011 I tried starting the car in neutral. No-go. Also, we used a meter to check the wire going to the starter solenoid and there was nothing while turning the key. that is exactly what wpuld happen if you tried to start the car in gear. Link to comment Share on other sites More sharing options...
nipper Posted June 2, 2011 Share Posted June 2, 2011 Im still leaning towards the inhibitor switch as it is rare for the ignition switch to go bad. Find the pins on the inhibitor switch thsat are there for the starter circuit and jump thme to see what it does Link to comment Share on other sites More sharing options...
General chaos Posted June 3, 2011 Share Posted June 3, 2011 the ignition switch electrical part can go bad. at least it can on my 93 legacy. the sprign inside of it can get weak and not let it contact properly. we were using a finger to press on the back of it to start the car. that gave more tention to the spring and the contact was made and the car started rigth up. we had to drive around withthe plastic cover off of the column . but it worked until we put in a new electrical switch. i had to drop the column down in order to remvoe the screws from the switch. there was no way what so ever to get any kind of small screwdriver in there at all. too much stuff in the way. it sat at the wrong angle too. towards the dash. Link to comment Share on other sites More sharing options...
nipper Posted June 4, 2011 Share Posted June 4, 2011 I did say rare not never, and a 93 is a different beats then a 98. I will stick by my statement and am still curios about the inhibitor switch. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now