seroius issue! Wire Elec. Connectors

[Suba_GL_87]

Hello NorthernWestern!:-\

i have a few problem...i was take out the engine of EA82 from my wagon and do rebuilding.

Somehow a brown wire just snap out, but i don't know where put connect on it because of my starter switch is not on the electronic even start it too.

 

I'm confused wire which to connect. i need your photo for

 

** Starter Motor connect which one right

 

** two wire (yellow/black wire to battery block?)

 

** (brown wire I'm unknow where that from)

 

HERE IS MY PHOTOS that what i have a serious issue! HELP ME.

Black/Yellow Wire to battery negative? or not?

 

that's where i found it and don't know where that from. while i was take out from engine EA82.

 

so, where that coming from?

 

IF you have a EA82 87' Subaru GL wagon--Check on your engine and take photo or explain to me.

thats only i need to know before road trip....

[johnny555]

Looks like a ground wire to me, usually goes from the battery to the negative terminal. If you look at your - terminal, you will probably see the little jacket the wire slipped out of.

[Suba_GL_87]

Looks like a ground wire to me, usually goes from the battery to the negative terminal. If you look at your - terminal, you will probably see the little jacket the wire slipped out of.

which one wire? you mean- black and yellow to negative terminal?

u have any know abt start motor connectors and brown wire?

sorry i dont get it.

[ruparts]

hi, the big black/yellow one ( 1st pic) goes to the bracket/ pipe that the top end of the lower radiator hose connects to , near the bottom of the battery , you should see a tab and bolt where it goes . the last one near your toes in the pic , looks like one end of a radio noise supressor condenser wire , but i'm not for sure. i don't know on the brown one.

[MilesFox]

It appears that the brown wire is replacing anoriginal wire that goes from the negative battery terminal to the same bolt on the water pupe that the body gtound goes(black w/yellow wire)

 

If you look at the bolt on the water pipe, you may see the other end of the connection

[MilesFox]

for the starter, the ground led will be on a bracket that the bellhousing bolt goes through on the top of the starter. The red pos cable bolts to the back of the starter on the top. There is a small single tab wire for the starter solenoid.

[Suba_GL_87]

everything is good!

but i don't know where brown wire coming from!:-\