EZ30 Tensioner Bearing Part Numbers And Belt Info:

[TheLoyale]

What is the PartsMaster or NAPA part number for the tensioner bearings on the EZ30? I assume both tensioner/idler use the same bearing, correct?

 

Looking at going to Napa or a simular parts house.

 

Cheers!

 

-Tom

Edited June 17, 2011 by TheLoyale

[CNY_Dave]

I used the NAPA

 

6203-2rsj

 

for both on my '03.

 

Not sure what the J means, the 2RS means 2 rubber seals.

 

One of them has a recess that keeps the nut from turning, once you pull the bolt the nut likes to fall out of the recess and disappear. A bit of tape over the hole keeps it in place nicely, just back up the tape with your finger when pushing on the bolt.

 

Dave

Edited June 16, 2011 by CNY_Dave

[CNY_Dave]

Also see

 

http://ultimatesubaru.org/forum/showthread.php?t=111279&highlight=6203

 

http://ultimatesubaru.org/forum/showthread.php?t=94497&highlight=6203

 

Dave

[TheLoyale]

Thanks for the heads up and the links!

 

-Tom

[TheLoyale]

Here is a Link with more EZ30 Belt info for future reference to anyone.

 

http://www.subaruoutback.org/forums/90653-post10.html

[KaraK]

Thanks for the info on my behalf, parts we used on 01 H6 EZ30...

(Parts Master)

PM 203FF 6203-2RSJ and a 30mm socket to pound them out/in.

[TheLoyale]

Thanks for the info on my behalf, parts we used on 01 H6 EZ30...

(Parts Master)

PM 203FF 6203-2RSJ and a 30mm socket to pound them out/in.

 

Yes, a 30mm socket is a must, it fits perfect and pushes on the outter race. The H6 is alive and happy again