Uberoo Posted July 30, 2011 Share Posted July 30, 2011 Ive had a intake manifold and wiring harness for a 93 subaru legacy sitting im my garage for a while just incase I wanted to put an EJ22 into my offroader. About two weeks ago I grabbed a long block from pull and save.however, stupid me I forgot to grab the bolts for the intake manifold-and the exhaust manifold gaskets... what is the thread size for those bolts?Length would be helpful but If I can find a bolt that will thread all the way down to the bottom I can figure out the length needed with my tape measure... Also would permatex ultra grey work as a gasket instead of the specified gaskets for the intake manifold?I'm down to my last $20 unless I can find another "handyman" type temp job... Link to comment Share on other sites More sharing options...
lmdew Posted July 31, 2011 Share Posted July 31, 2011 12 mm I don't have the pitch. They are about 2" long. I'd just hit the yard and pull another set. Link to comment Share on other sites More sharing options...
Uberoo Posted July 31, 2011 Author Share Posted July 31, 2011 the yard is 2 hours one way. Link to comment Share on other sites More sharing options...
lmdew Posted July 31, 2011 Share Posted July 31, 2011 I could mail you a used set if you want $15.00 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now