Jump to content
Ultimate Subaru Message Board

My 87 GL-10


Recommended Posts

Here's some pics of my ride :

 

1987 Subaru GL-10 4WD 3AT w/102k miles

 

100_0380.JPG

 

100_0381.JPG

 

100_0386.JPG

 

100_0387.JPG

(2) MTX Thunder 8000 10's in a Sealed Box w/JBL Power 600.1 AMP

 

100_0391.JPG

 

100_0396.JPG

 

100_0400.JPG

5300k REAL HID HEADLIGHTS!

 

100_0402.JPG

Pioneer Premier DEH-24F Headunit

 

 

Here are some clips of the exhaust, I removed the OEM Muffler and have a open pipe setup :

 

Clip #1 (inside car) Start and Idle, REV to 3k, then REV to 7k

http://www.purehardware.com/subaru/videos/100_0411.MOV

 

Clip #2 (outside car behind tail pipe) Start and Idle, REV to 3k, REV to 5k and Hold

http://www.purehardware.com/subaru/videos/100_0412.MOV

 

 

Enjoy and let me know what ya think.

 

Tell me what ya think.

Link to comment
Share on other sites

It pounds hard enough to give me a headache/earache if I keep it up :banghead::headbang:

 

 

The subs I got a killer deal on, $65.00 each at a local place on clearance :)

 

 

The amp I got awhile ago for $200.

 

 

 

They can be had for less than that now, VERY good amp pushes more than advertised power rating and never shuts off under 100% load, I have it running at 2ohm right now but I've run it at 1ohm just fine, never quit.

 

 

The headunit is ok and sounds good, but nothing like my Alpine CDA-9815 that I have in my Legend :)

Link to comment
Share on other sites

Thanks for all the replies, the dash kit was NOT an easy one to find, I got the last one in the Portland Metro Area since they stopped making the kit years ago and is a special order only and even then he said he had no idea when I could get it.

 

 

If you must have one goto Stereo King in portland on 82nd ave. They can order you one but it might take a few weeks.

 

 

I just ordered a manual boost controller, 2 gauge a-piller POD, and a Boost Gauge, for my attempt to raise the boost a bit. I plan on redoing the exhaust with 2-inch stainless piping and fitting a high flow cat in place of the stock unit, then I'm planning on a APEX N1 Race Muffler.

 

I'm workin on modifying the air box right now with a cone filter and some kind of box to sheild the filter from HOT underhood air and dirt, I want to vent it to the fendor.

 

I'm making a website for the car so everyone can track the progress of the project.

Link to comment
Share on other sites

  • 5 months later...

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...