Dirthead Posted August 27, 2011 Share Posted August 27, 2011 (edited) Need a little help. I have a 99 legacy that I have built a Franken motor for. The motor is installed and everything is connected. I attempted to start it and it will turn over but will not start/idle ... nothing. This is what I have. Motor: 96 ej25 block - phase I 94 - 95 ej22 sohc heads - phase I 99 legacy ECU Intake: ej22 Injectors: ej25 usdm Timing: All ej22 timing belt, idler pulleys, tensioner. Wiring: All EJ25 with the exception of the ignition plug Ignition: EJ22 MAF: EJ25 w/ ej25 sensors When I attempt to start I am getting spark and fuel. Any ideas would be greatly appreciated. The previous motor ran (2.5 dohc phase I) up until I removed it. The previous motor was pull because of a thrown main bearing. Edited August 27, 2011 by Dirthead Specifics Link to comment Share on other sites More sharing options...
WoodsWagon Posted August 28, 2011 Share Posted August 28, 2011 You either don't have something plugged in, like a coil, ignitor, or crank/cam sensor, or you didn't line the timing belt marks up right. Did you use the big arrows, or the small tic marks? Link to comment Share on other sites More sharing options...
Dirthead Posted August 28, 2011 Author Share Posted August 28, 2011 I used the big arrows and made sure that they pointed at the marks on the timing belt covers. Link to comment Share on other sites More sharing options...
WoodsWagon Posted August 28, 2011 Share Posted August 28, 2011 That's your problem then. You need the small tic marks lined up with the valve cover notches and the small tic on the crank sprocket reluctor tooth lined up with the tic on the crank sensor mounting boss. The big arrows are a red herring that has screwed up many t-belt jobs. I've done it myself, once. They're there for a different purpose, possibly adjusting valve lash or something. Ignore them and go by the small tic marks. Get the belt set right and it should fire right up. I would doubt you bent any valves, but the EJ25d pistons do stick higher up than the EJ22 pistons, so there is a chance. Link to comment Share on other sites More sharing options...
Dirthead Posted September 3, 2011 Author Share Posted September 3, 2011 WoodsWagon, Nice work that was it. Reset the timing belts and verified that I had the correct marks from (Legacy777 EJ22 timing)- (subaru_manual_scans). Thank you so much for your help, its been an amazing experience finishing this project. I don't know if this setup has been done before, but we now have a 99 Legacy GT running off a FrankenMotor. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now