zeke998 Posted May 24, 2012 Share Posted May 24, 2012 Long story short I pulled engine and changed the clutch. Now I got check engine light and an egr code. The car now stumbles and I hear cycling sound in the ecu. Any ideas? It is a 94 Loyale wagon. Thanks Link to comment Share on other sites More sharing options...
skishop69 Posted May 24, 2012 Share Posted May 24, 2012 Bad ground. Check your connections at the main connectors and the grounds to the block. Particularly the one to the pass side of the intake. Link to comment Share on other sites More sharing options...
man on the moon Posted May 25, 2012 Share Posted May 25, 2012 Probably not the ECU, more likely a relay clicking. The ignition and fuel pump relays are only a few inches from the ECU. That is a normal sound for a relay, NOT a normal sound for the ECU. The ECU has no moving parts to click--if it IS clicking, it probably isn't working. Link to comment Share on other sites More sharing options...
ivans imports Posted May 25, 2012 Share Posted May 25, 2012 unplug the green diagnostic conector on the ds side firewall there is two a black single wire ones and green two wire ones probly pluged in when job was done they are just for timing and diagnostic and should be left unpluged Link to comment Share on other sites More sharing options...
zeke998 Posted May 26, 2012 Author Share Posted May 26, 2012 The test connectors are unpluged. The clicking is from relay just above the ecu. What would this relay control? :banghead:The car starts and idles fine just stumbles under load. 2-3 grand on tach. Got new plugs and fuel filter. Don't have a ground to intake on passenger side. Going to check grounds and try coding again tomorrow. Link to comment Share on other sites More sharing options...
ivans imports Posted May 26, 2012 Share Posted May 26, 2012 the clicking is the feul pump realy or ig realay Link to comment Share on other sites More sharing options...
man on the moon Posted May 26, 2012 Share Posted May 26, 2012 Relays normally click when they first power up. Are you trying to say they click continuously? They should just click a couple times when you start the car, and the fuel pump relay may click occasionally as it powers up and down while you drive, though not continuously. Link to comment Share on other sites More sharing options...
ivans imports Posted May 29, 2012 Share Posted May 29, 2012 feul lines on backwards ? or pinched wire harness or no ground check where the main engine harness plugs together mabee dident plug in properly sometimes the pins get bent and miss the conector Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now