Speedwagon Posted May 29, 2012 Share Posted May 29, 2012 I extended my radius rods 1" today. The tires(215/75/15) were rubbing against the rear fender well in tight turns(EA82 front end swap into a Brat). 1 3/8" stock, cut to 2" length, then drilled and lathed to give a clean 1/2" depth hole on both sides: Link to comment Share on other sites More sharing options...
spazomatic Posted May 29, 2012 Share Posted May 29, 2012 how did you deal with the misalignment where the lower control arm meets the crossmember? Link to comment Share on other sites More sharing options...
Speedwagon Posted May 29, 2012 Author Share Posted May 29, 2012 how did you deal with the misalignment where the lower control arm meets the crossmember? I kept the control arm in the xmember, and just pushed until things lined up. At only 1" it's not too far forward from where it naturally wants to sit. The stock radius rods, with the EA82 front end, actually pulled the control arm slightly behind the neutral position. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now