BobBrumby Posted March 28, 2004 Share Posted March 28, 2004 When you are removing the mech fan do you put a pully inplace of the fan pully that was there? Or could you just use a smaller fan belt? Link to comment Share on other sites More sharing options...
subusolo2nut Posted March 28, 2004 Share Posted March 28, 2004 Well-if the pulley runs the water pump--no pulley = no cooling. I'd put real short bolts in the pulley (remember to use blue locktight on them;) ) & put a new belt on Link to comment Share on other sites More sharing options...
oddcomp Posted March 28, 2004 Share Posted March 28, 2004 if your just removing the mechanical fan to make room for a electric one or waht ever the mechanical fan actually bolts on top of the water pump pulley so they are 2 seperate doohickys just take off the fan use a few washers to equal the thickness of the fan hub and put your old nuts/bolts back on to keep the pulley in place and there ya go no need for a new belt or anything Link to comment Share on other sites More sharing options...
Snowman Posted March 28, 2004 Share Posted March 28, 2004 Actually, when removing the mechanical fan, if it's attached to the water pump, you can just turn the studs around in the mounting flange and bolt the pulley right back on. Link to comment Share on other sites More sharing options...
BobBrumby Posted March 29, 2004 Author Share Posted March 29, 2004 you can just turn the studs around in the mounting flange and bolt the pulley right back on.What do u mean that?Could you please explain that again? I got a spare one sitting under my house and I have just had a look at it but couldn't get the pulley thing off the rod after unscrewing the fan and alliminium cap. This is because I could get the second bigger "U ring" (i think thats what it called) out with my plyer thingies. And yeh the belt does run the water pump. Link to comment Share on other sites More sharing options...
Snowman Posted March 29, 2004 Share Posted March 29, 2004 Hmmmm, I've never looked at an ea81 mechanical fan before. They may be different. On my ea82, the flange that's attached to the water pump has four studs that screw into it. The pulley goes on these studs, then the fan, then the nuts. I normally take off my mechanical fan during the winter, and I just take off the nuts, take the fan off, then the pulley slides right off. Unscrew the studs and turn them around so the shorter side now faces out, put the pulley on, and tighten down the nuts. Link to comment Share on other sites More sharing options...
BobBrumby Posted March 29, 2004 Author Share Posted March 29, 2004 nah the fan has a pulley seperate to the alt but the fan unit has the alt mounting on it with out the fan pulley i think the belt wont be tight enought i could take some photos tomorow if that could help Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now