JWX Posted April 7, 2004 Share Posted April 7, 2004 on my 87 GL-10 SPFI how do I do it? I've looked at the ECU and I don't see any lights on it. I searched before and found skips(I think it was his anyway) write up on how to do it but I forgot and can't find it now Link to comment Share on other sites More sharing options...
JWX Posted April 7, 2004 Author Share Posted April 7, 2004 and I have a green -l and a white - connector which one do I need to have pluged in to check the codes Link to comment Share on other sites More sharing options...
lagwagon Posted April 7, 2004 Share Posted April 7, 2004 you must remove the panel below the streering wheel (the same panel as your fuse box).I cut a little hole in the panel so I didn't have to remove it everytime I had a check engine warning.You also need to have the key in and turned to ON.I hope that helps. Link to comment Share on other sites More sharing options...
JWX Posted April 8, 2004 Author Share Posted April 8, 2004 wheres the light, and which connector gets connected? Link to comment Share on other sites More sharing options...
gravelRX Posted April 8, 2004 Share Posted April 8, 2004 Light is on the side of the ECU. IIRC, If you have a hard code it will flash without the connectors connected. If not, with the key off, plug in the white(single plug harness), mines brown. Turn on the key, stare at little green light. There's more but I gotta go to bed. Jay Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now