NorthCoast Posted November 16, 2012 Share Posted November 16, 2012 I had to swap my engine due to a blown ring and now after the swap I only have 4high and low. When I try to shift between 2and 4 there is nothing where 4 high should be and 4 high is where 2 should be. Any ideas? Link to comment Share on other sites More sharing options...
Subafreak Posted November 16, 2012 Share Posted November 16, 2012 Did you have the tranny out when you swapped the motor for some reason? Sounds like you may have to adjust the 4WD lever. If you take apart the console around the shifter there should be an adjusting nut under there......if memory serves me rite. Link to comment Share on other sites More sharing options...
NorthCoast Posted November 17, 2012 Author Share Posted November 17, 2012 No adjusting nut. It's welded to the shifter. Fixed it by driving back and forth and pushing the shifter down. Link to comment Share on other sites More sharing options...
tractor pole Posted November 17, 2012 Share Posted November 17, 2012 No adjusting nut. It's welded to the shifter. Fixed it by driving back and forth and pushing the shifter down. I had the same problem after my d/r swap, driving on dry pavement bound up the shifter... drove in circles in reverse to unbind it. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now