Jump to content
Ultimate Subaru Message Board

83 GL Clutch Replacement


Recommended Posts

It is easier to slide the engine forward. this can be done with 2 men and no crane. But if you went that far, you can just lift the motor out.

 

If you are trying to work from underneath, you have to separate the trans from the engine some 3 inches to clear the studs just to get in there, and by then you may have well removed it.

 

You would have wanted to remove the axles from the trnas stub, which you would have had to undo the ball joints to allow the room. The axles are pressed into the bearing, so by removing the nuts, all you can take off is the hub and rotor but the axles are still in the hub.

 

search the 'tube for 'art of subaru maintenance' to see some clever engine/trans wrangling

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...