Spacecadetchickn Posted February 20, 2013 Share Posted February 20, 2013 Hey guys I have 2 issues.. After a swap I'm missing a control unit under the dash( not sure what it is/does... And I don't have the fuel pump working ...(might b related) please help... Btw I took a 94 legacy sedan lsi chassis and put a 99OBW drivetrain(motor/trams/diff axles sturs hubs tires etc. aswell as the entire body harness fuel pump and dash.. Big frenchin project by yourself!( I did not use the OB gas tank, evap box, or drvr side sending unit. I'll post some pics when I figure out how! Lol! Link to comment Share on other sites More sharing options...
ShawnW Posted February 21, 2013 Share Posted February 21, 2013 Sounds like a lot of work. Pictures will certainly generate interest here. Link to comment Share on other sites More sharing options...
Gloyale Posted February 21, 2013 Share Posted February 21, 2013 You are missing the fuel temp sensor, and the feul pressure vent solenoid and evaporate canister. Shouldn't prevent fuel pump running, but could cause cel. Link to comment Share on other sites More sharing options...
Spacecadetchickn Posted February 21, 2013 Author Share Posted February 21, 2013 Not too worried about a cel for that as my understanding is it should run fine without those... I haven't been able to get a cel at all since the swap... I'm pretty sure these have something to do with it. Not sure what they are/do...(not the check connectors) Link to comment Share on other sites More sharing options...
Spacecadetchickn Posted February 21, 2013 Author Share Posted February 21, 2013 Plugs in question... Link to comment Share on other sites More sharing options...
Spacecadetchickn Posted February 21, 2013 Author Share Posted February 21, 2013 Some other pics of the leggy...she sits this way now Link to comment Share on other sites More sharing options...
johnceggleston Posted February 21, 2013 Share Posted February 21, 2013 the white connector is for the subaru'' select monitor'' or something like that. the black connector is for diagnoing trouble codes for the trans, air bags and ABS if ytou have them. Link to comment Share on other sites More sharing options...
Spacecadetchickn Posted February 21, 2013 Author Share Posted February 21, 2013 I deleted the abs ... No airbags and what's the select monitor? Link to comment Share on other sites More sharing options...
Spacecadetchickn Posted February 21, 2013 Author Share Posted February 21, 2013 Ok so probably not my issue.... Now the only wires I cut were to the evap box in the back because it was mangled anyway. Does power go to the evap box then to the FP? Pump turns on with a hardwire but not connected normally. Also does not explain the absence of a CEL when ignition is on. Thinking with my fingers sorry. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now