Not in the service manual- gen 2 trans connector pinout

[CNY_Dave]

2003 outback with the H6, I have the trans connector B11 all pinned out except for pins 7, 10, and 16. Hoping one of these is +12V switched by the ignition. Surely at least one will be ground.


Anyone have an ID on these pins?

[Fairtax4me]

Closest I have is 2000. It shows 3 connectors, B54, B55, and B56.

Without VDC:

B54

7: Shift solenoid 1. 1st or 4th gear >9v, 2nd or 3rd gear <1v.

10: Range 2 switch position. In range 2: <1v. Any range except 2: >8v.

16: Lock-up Duty Solenoid. More than 8.5v with lockup, less than 0.5v without lockup.

B55

7: SSM data link signal

10: sensor ground 1

16: SSM data link signal

With VDC:

B54

7: Lock-up Duty Solenoid. When lockup >8.5v, when not lockup <0.5v.

10: Intake manifold pressure signal. 1.2-1.8v

16: 2-4 brake timing solenoid. 1st gear <1v, 3rd gear >9v

B55

7: Range 1 switch position. In range 1: <1v, any range except 1: >8v.

10: Torque control cut signal. Ign switch ON: 8v.

16: none

B56

7: none

10: AT Oil Temp warning light. Light on <1v, light off >9v.

16: none

 

I got this manual from here: http://www.main.experiencetherave.com/subaru_manual_scans/

Edited February 27, 2013 by Fairtax4me