el_freddo Posted May 18, 2018 Share Posted May 18, 2018 I can't access Ausubaru.com/forum via my phone (that I'm on now), but if anyone is using an old version of internet explorer or Firefox you'll be able to access the address above and look at more than one page a day. On that site one of the members (Bantum) has posted details of these rings for 3D printing. Follow the link and I believe you down load the details then go nuts with the printing Cheers Bennie Link to comment Share on other sites More sharing options...
DaveT Posted May 18, 2018 Share Posted May 18, 2018 I found a couple, and a broken one. I will make a model and drawing so you can check the dimensions. They look like the thicker one, at first glance. Link to comment Share on other sites More sharing options...
DaveT Posted May 19, 2018 Share Posted May 19, 2018 The inside groove measures .288" The outer thickness is .510" The flange on one side is about double the thickness of the other. Does this sound like the part you are looking for? Link to comment Share on other sites More sharing options...
Checkerboard Comet Posted May 21, 2018 Share Posted May 21, 2018 My buddy is printing them now on his printer, I hope they work! Link to comment Share on other sites More sharing options...
Checkerboard Comet Posted May 21, 2018 Share Posted May 21, 2018 Will post picks when I get them... Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now