Jump to content
Ultimate Subaru Message Board

'92 Legacy Turbo auto trans. vs. N/A auto trans.


Recommended Posts

The auto trans on my '92 Legacy SS turbo seems to be going out. I'm not in a position to do a 5-speed conversion right now, but I have a chance to pick up a low-mileage auto trans from a non-turbo '92 for cheap. Does anyone know how the gearing compares, or how it might change the driving experience? I believe the final drive ratio is the same at 3.90. Thanks.

Edited by dave833
Link to comment
Share on other sites

I would say the difference i the final gear and perhaps the tcu programming, or just the input from the engine (load, rpm, etc) regardless. Sorry i don't have a specific answer on this one. A n/a trans should be a 4.11 gear but do a search to make sure.

Link to comment
Share on other sites

92-94 legacy autos were all 3.9......nope just swapped a 93 rearend/4.11 into a 92 cause the 90 tranny I swapped was 4.11 and 92 rear end was 3.90, b0y is this fun!?????...............G

Edited by gbianchi
Link to comment
Share on other sites

92-94 legacy autos were all 3.9......nope just swapped a 93 rearend/4.11 into a 92 cause the 90 tranny I swapped was 4.11 and 92 rear end was 3.90, b0y is this fun!?????...............G

You pulled that 93 rear end from a MT car (which were 4.11)  OR it had been switched before.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...