TOsborn Posted May 20, 2013 Share Posted May 20, 2013 While poking around my engine bay, I found that the wiring to this sensor was severed. Problem is, I can't figure out what sensor it is. Going to be fixing it soon, just need to run to the junkyard to grab a connector off another EA82T and splice it in. It's the sensor circled in red. Behind intake, next to bell housing. Knock sensor? Link to comment Share on other sites More sharing options...
Turbone Posted May 20, 2013 Share Posted May 20, 2013 Pretty sure your right about it being knock sensor Link to comment Share on other sites More sharing options...
TOsborn Posted May 20, 2013 Author Share Posted May 20, 2013 Thanks. I was looking at a GL-10 at the local junkyard, which also had an EA82T, and it didn't seem to have this sensor. Seems odd that different generations came with/without a knock sensor. Link to comment Share on other sites More sharing options...
leniac Posted May 20, 2013 Share Posted May 20, 2013 the knock sensor is more slim... but also is the only electronic cable that belong to that part of the engine.... Link to comment Share on other sites More sharing options...
Gloyale Posted May 20, 2013 Share Posted May 20, 2013 85/86 flapper MAF type use a 2 wire Knock sensor. Round connector 87+ Hotwire MAF uses a one wire. slim round connector The CTS is in that area too. square 2 wire Link to comment Share on other sites More sharing options...
TOsborn Posted May 20, 2013 Author Share Posted May 20, 2013 Thanks, guess its a knock sensor then! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now