herb Posted July 9, 2013 Share Posted July 9, 2013 I DID search, and found a bit of info, but not quite enough. I'm in the process if having my motor mounts replaced on my ej'd ea82 and I'm running into some difficulty apparently (outback auto is handling the job on my behalf, as I don't have a hoist or, quite frankly, the time). They are saying the group n mounts don't seem to line up quite right going in, that they are too wide but from my understanding all ej mounts are the same? can anybody provide some quick insight for my ignorance? THANK YOU! Link to comment Share on other sites More sharing options...
bratman18 Posted July 9, 2013 Share Posted July 9, 2013 I have heard that some people need to widen the engine mount holes in the crossmember when doing the EJ swap, so it could be just as simple as that. The Group N mounts are much stiffer so they might not have enough play in them to be persuaded into the existing holes. Link to comment Share on other sites More sharing options...
herb Posted July 9, 2013 Author Share Posted July 9, 2013 any idea on how much they would need to be widened? could that be accomplished with a dremel and a few minutes, or is it a more serious affair? excuse my ignorance, but I don't have it in front of me to visualize. and again, thank you. Link to comment Share on other sites More sharing options...
Gloyale Posted July 10, 2013 Share Posted July 10, 2013 Group N mounts have the little extra locating knob, as do some factory EJ mounts. These nubs either need to be ground off, or the holes lengthed. Easy to do with a dremel. Link to comment Share on other sites More sharing options...
ShawnW Posted July 11, 2013 Share Posted July 11, 2013 Die grind the hole about an additional 1/2 of what is there already outward. ( ) becomes ( ) toward the outside of the car on each side. Link to comment Share on other sites More sharing options...
herb Posted July 11, 2013 Author Share Posted July 11, 2013 understood. THANK YOU so much for the explanation guys, much appreciated. Link to comment Share on other sites More sharing options...
drugh Posted July 11, 2013 Share Posted July 11, 2013 Not to contradict others, but I've got group N engine mounts in my Phase 1 EJ 2.2 swapped Loyale and they dropped right in without any grinding or cutting of anything. They cause some vibrations at stoplights but they feel great when driving hard. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now