rkautar Posted October 8, 2013 Share Posted October 8, 2013 Guys, I need help again. Just replaced the pressure control solenoid and 2-4 Brake solenoid on my transmission which was in limp mode (first and straight into 3rd where in stayed). I took it for a run and it is still doing the same thing, although the codes are now P0748 and P0771. I am low on fluid as I did not have enough. One of the causes on goolgling states "low fluid". I hope this is the issue but any suggestions in the meantime would be welcome as I will be ready tomorrow. Thanks Quote Link to comment Share on other sites More sharing options...
Legacy777 Posted October 13, 2013 Share Posted October 13, 2013 Did adding more fluid help or are you getting the same codes? Quote Link to comment Share on other sites More sharing options...
rkautar Posted October 14, 2013 Author Share Posted October 14, 2013 Hello Josh, added more fluid and still the same codes and 1st and 3rd gears only. Thanks Quote Link to comment Share on other sites More sharing options...
Legacy777 Posted October 14, 2013 Share Posted October 14, 2013 Did you have all the gears before taking the trans apart to do the work? If so, then I would suspect something may not have been put back together properly or the solenoids you put in may not be working. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.