86subaru Posted October 27, 2013 Share Posted October 27, 2013 Hestation problem. Changed fuel filter ran ejector n it.cleaned mass air flow.no code or check engine light on. Any help Link to comment Share on other sites More sharing options...
MilesFox Posted October 27, 2013 Share Posted October 27, 2013 (edited) Is it a misfire or a stumble. I ended up swapping all of the components on mine to figure out the sparkplug wires were shot. It would only misfire under load, but idle fine, and cruise fine until adding more load. This triggered the check engine lite for cyl misfire, and would flash while actively misfiring. Edited October 27, 2013 by MilesFox Link to comment Share on other sites More sharing options...
86subaru Posted October 27, 2013 Author Share Posted October 27, 2013 Ok Link to comment Share on other sites More sharing options...
86subaru Posted October 27, 2013 Author Share Posted October 27, 2013 Stumble Link to comment Share on other sites More sharing options...
MilesFox Posted October 27, 2013 Share Posted October 27, 2013 How is the knock sensor> does it stumble under load or on hils? Link to comment Share on other sites More sharing options...
86subaru Posted October 27, 2013 Author Share Posted October 27, 2013 Coil pack?? Link to comment Share on other sites More sharing options...
86subaru Posted October 27, 2013 Author Share Posted October 27, 2013 After car warmed up.stop car.and start to go Link to comment Share on other sites More sharing options...
Rooster2 Posted October 28, 2013 Share Posted October 28, 2013 When last time plugs and plug wires changed?? Link to comment Share on other sites More sharing options...
86subaru Posted October 28, 2013 Author Share Posted October 28, 2013 Not it is not mine. Sister in law.will change them .since i have a set Link to comment Share on other sites More sharing options...
MilesFox Posted October 28, 2013 Share Posted October 28, 2013 remove the airbox and the washer fluid jug to get at them easier. Link to comment Share on other sites More sharing options...
Prwa101 Posted October 29, 2013 Share Posted October 29, 2013 When was the timing belt done? Possible timing slip issue. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now