Jump to content
Ultimate Subaru Message Board

Recommended Posts

Yes it has a filter. More then likely in the pan style, IIRC they didn't have the screw on kind until 2000. Drain, drop pan, change filter, re-seal. Add trans-X first, then top off with regular DEX-Merc or Chevron MDIII…see of that helps. If not, you may be headed towards the land of duty solenoid 3 failure ala torque bind. 

Link to comment
Share on other sites

 

does the ATF temp light flash on startup?

 

this^.

 

any work done recently ?

 

i had a really squirrelly issue with my 00 lego which was caused by a loose ground wire.

i failed to tight the bolt holding the ground wire.

but the problem did not occur for months,

until i replaced an axle and knocked it loose.

 

the trans would usually shift up to D but then for no reason it would down shift to 3.

if i shifted in to 3, it would down shift to 2, sometimes.

it gave me a flashing AT Temp light when i was driving .

but not at start up, and no trans codes.

 

i found one reference to a similar problem on line, here i think, in a 96 outback.

and went looking for a loose wire.

and i found it.

 

i was really scared i was looking at a new trans.

Edited by johnceggleston
Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...