jimmyberka Posted March 28, 2014 Share Posted March 28, 2014 (edited) I just got a 9pin adaptor to read OBD (using an OBD2 code eader) codes for my 93 Legacy. Does anyone know where the 9 pin connecrtor I need to plug it in is located? Thanks Edited March 28, 2014 by jimmyberka Link to comment Share on other sites More sharing options...
Fairtax4me Posted March 28, 2014 Share Posted March 28, 2014 It plugs into the yellow connector under the drivers dash. Near the steering column. This will only work if your code reader is designed to read OBD1 codes. If you have a basic OBD2 code reader it will probably not communicate with the car. This will only allow you to read codes from the ECM, which can also be done without the use of a scanner. It will not read TCU, ABS, or Airbag codes. Link to comment Share on other sites More sharing options...
jimmyberka Posted March 28, 2014 Author Share Posted March 28, 2014 OK, thanks, The green connector wires are so short, I can't get them plugged together to do the self diagnosis. Has anyone else had this problem? Link to comment Share on other sites More sharing options...
heartless Posted March 29, 2014 Share Posted March 29, 2014 OK, thanks, The green connector wires are so short, I can't get them plugged together to do the self diagnosis. Has anyone else had this problem? undo some of the tape holding the wires to the main harness. the wiring is folded up and taped down from the factory Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now