kevinrse Posted May 5, 2014 Share Posted May 5, 2014 I need to clean up the threads inside my crankshaft. Made a mistake using a puller; got a small piece of metal jammed in the crankshaft end but fished it out with some epoxy. I want to clean the threads up before putting it back together. I am measuring thread spec using my crankshaft bolt and calipers. By my measurements major thread diameter = 12.8 mm, thread pitch = 1.5 mm (averaged along 15 threads). Should I assume that the proper tap size = M13x1.5? (The reason I come here to verify is because M13 isn't a common size, so I want to make sure I'm right before I order the tap). Thanks. Link to comment Share on other sites More sharing options...
Fairtax4me Posted May 6, 2014 Share Posted May 6, 2014 I want to say its M12x1.5 Take the bolt to a Fastenal store, or any store that sells specialty hardware, and they can measure it. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now