Gwywnc Posted June 16, 2014 Share Posted June 16, 2014 Subaru gl I'm putting a 4 speed trans n and I got it on the bottom studs but can't get it to go all the way in. And advise tips or tricks? I'm working wth a floor jack and a screw jack thanks Link to comment Share on other sites More sharing options...
MR_Loyale Posted June 17, 2014 Share Posted June 17, 2014 Wiggle jiggle curse and swear. Link to comment Share on other sites More sharing options...
Padawan Posted June 18, 2014 Share Posted June 18, 2014 Manual trans? If so I suppose you've aligned the clutch disk? Link to comment Share on other sites More sharing options...
Subaru_dude Posted June 19, 2014 Share Posted June 19, 2014 I ran into the same problem installing a 4spd 2wd, it was like the input shaft didn't want to slide into the pilot bearing. I got a nut started on the bottom driver side and a bolt and nut started on the passenger top and just forced it in. Didn't damage anything amazingly. Link to comment Share on other sites More sharing options...
markjw Posted June 19, 2014 Share Posted June 19, 2014 If the tranny or engine are new, meaning they've never been mated up before, make certain you don't have too many locating pins. It's easy to miss a pin in the mating surface of the tranny when you already have one in it's opposing position on the engine. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now