Subarocket Posted July 29, 2014 Share Posted July 29, 2014 I haven't had much luck in any other forums so I figured I would try here. I would like to buy the 1.1/4" spacers from the engine and transmission crossmembers on a 95-99 outback. I will pay to have someone take them off a parts car or wrecker. Link to comment Share on other sites More sharing options...
Fairtax4me Posted July 29, 2014 Share Posted July 29, 2014 Spacers on the trans cross member are welded on so you need the whole thing, plus bolts. You will also need the transverse bushings for the front control arms. Link to comment Share on other sites More sharing options...
Subarocket Posted July 29, 2014 Author Share Posted July 29, 2014 What are the LCA bushings for? I am liftin my 92 loyale 2" and dropping the engine and tranny. Link to comment Share on other sites More sharing options...
Gloyale Posted July 30, 2014 Share Posted July 30, 2014 (edited) Spacers on the trans cross member are welded on so you need the whole thing, plus bolts. You will also need the transverse bushings for the front control arms. No they aren't. the paint sticks them toghether. they wack off with a hammer. You don't need the LCA's with EA lift. that's if lifting form Leg/Imp to FOR/OBK stuff. Edited July 30, 2014 by Gloyale Link to comment Share on other sites More sharing options...
Gloyale Posted July 30, 2014 Share Posted July 30, 2014 SubaRocket you will also remove the rear crossplate that is just behind the shifter across the tunnel......it will hit the dirveline otherwise once lowered. Link to comment Share on other sites More sharing options...
Fairtax4me Posted July 31, 2014 Share Posted July 31, 2014 The last ones I saw definitely had a couple tack welds. Maybe that was someone's approach to make them stay put during removal/install of the crossmember. I wasnt aware the OB cross member spacers were commonly used with EA lifts. Hockey pucks are cheap and easy to drill through. Link to comment Share on other sites More sharing options...
upnorthguy Posted July 31, 2014 Share Posted July 31, 2014 Hockey pucks are cheap and easy to drill through. OK for use where winter temps are "warmer." Used in a coldish place, pucks often crack. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now