Jump to content
Ultimate Subaru Message Board

Please help... middle of swapping EJ25's and realize this... What now?


KEGMotorsports
 Share

Recommended Posts

Can someone please help me out... I am savvy turnin wrench's but I am not super familiar with Subarus.

So here's where I'm at, I bought a good used EJ25 to swap the EJ25 in the Mrs's Outback. Now that I have the rented engine hoist in the garage, long block to swap in on the garage floor ready to swap in, I start stripping down the motor in the car to pull and then realize the heads are different... manifold looks to be different, but to my eye everything else looks the same.

So here is the existing motor/head...
https://www.facebook.com/photo.php?f...4&l=4bf238d1bc

https://www.facebook.com/photo.php?f...0&l=73830742ff

Here is what I "planned" to swap in...
https://www.facebook.com/photo.php?f...3&l=aec137cf78

https://www.facebook.com/photo.php?f...0&l=55cb9b6633

Considering there is obviously a difference, what are my options? 
I was told the motor was from a 99, the vehicle is an 01 (Legacy Outback, Auto)

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...