myhilo Posted November 4, 2014 Share Posted November 4, 2014 Speedo Cable to Trans, remove how? 79, EA81 wagon 4WD, 4sp dual range manual transmission. The Speedometer Cable has a rubber/plastic boot which I have slid upward to expose a ~1/2 diameter collar then a hex fitting which a 17mm fits onto loosely. the 17 mm hex is about 1" long and seems to be made of plastic although it's blacked by crud and doesn't seem to clean up with penetrating spray. When I turn the 17mm Hex counterclockwise as viewed from above it seems to flex but NOT UNSCREW. If it's plastic I may break it or strip any plastic threads going into the transmission. How does the cable come out?? Link to comment Share on other sites More sharing options...
l75eya Posted November 4, 2014 Share Posted November 4, 2014 (edited) If it's anything like on an ea82 car (and it sounds like it is) it is plastic and i basically destroyed the one on my car getting it off. Once it's threaded out, it pulls straight up and out. The correct 17 mm wrench fits but then the plastic flexes and the wrench slips. Why in God's name is it made out of plastic? Edited November 4, 2014 by l75eya Link to comment Share on other sites More sharing options...
myhilo Posted November 4, 2014 Author Share Posted November 4, 2014 Thanks for your quick reply, So it should loosen by turning Counterclockwise and if it doesn't break, it will unscrew, correct? From your comments I am planning on using penetrating oil and double wrenches to spread the forces out on the hex part. Link to comment Share on other sites More sharing options...
l75eya Posted November 4, 2014 Share Posted November 4, 2014 It is normal thread. Once it turns a couple times it should be pretty free. Two wrenches. I should have thought of that. Good idea. Best of luck Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now