bratlife Posted April 19, 2015 Share Posted April 19, 2015 Does anybody know any tricks to pull out a pilot bearing? None of my local parts stores have a bearing puller that is small enough to fit through the middle of the bearing. Its a little less than an inch inside diameter. I tried packing the hole with grease and then taping a bolt the size of the hole with a hammer to push it out with pressure from behind it. But the front seal got pushed off the bearing, so now when I try that all the grease just comes right through the bearing, since its just exposed ball bearings now without a seal to make it air tight. Its on an EA81. Any ideas would be greatly appreciated. I really need to get this tranny in there this weekend and I'm stuck on one little bearing. Thanks a bunch. -Scott Link to comment Share on other sites More sharing options...
Crazyeights Posted April 19, 2015 Share Posted April 19, 2015 (edited) I would just pull off the flywheel and tap it out from the back side I have a pilot bearing puller with both small and large jaws but I have never had to use it on an EA81 or EA82. Good Luck! Jeff Edited April 19, 2015 by Crazyeights 1 Link to comment Share on other sites More sharing options...
l75eya Posted April 20, 2015 Share Posted April 20, 2015 Take off the flywheel and set it on a flat surface. Get a socket that is about the same size and lay it on the bearing and tap tap tap it out. Link to comment Share on other sites More sharing options...
bratlife Posted April 20, 2015 Author Share Posted April 20, 2015 Thanks a bunch guys! I can't believe I didn't think even think of taking the flywheel off. Haha. It took less time to take it off and tap the bearing out than to go ask questions about it on the computer, haha. Thanks again. Link to comment Share on other sites More sharing options...
Crazyeights Posted April 20, 2015 Share Posted April 20, 2015 Thanks a bunch guys! I can't believe I didn't think even think of taking the flywheel off. Haha. It took less time to take it off and tap the bearing out than to go ask questions about it on the computer, haha. Thanks again. To be fair this trick doesn't work on a lot of cars Link to comment Share on other sites More sharing options...
coxy Posted April 20, 2015 Share Posted April 20, 2015 Hydraulic Lifter removal slide hammers work for removing pilot bearings for engines where the bearing is fitted into the crank as well as obviously the dedicated tool for the Job. But with pushrod V8's being so common in the US you can more easily find a lifter puller than a Pilot bearing puller. Link to comment Share on other sites More sharing options...
idosubaru Posted April 21, 2015 Share Posted April 21, 2015 gaaah! others aren't so simple! my Ford F 150 still has the pilot bearing stuck in it from a clutch job i started a long time ago. pilot bearing puller didn't work all the youtube tricks didn't work - grease, punching it out. no one seems to know how to get it out - i called a 30 year Ford technician and the tool doesn't work. high quality drill bits walk across the surface. a rsaw has no stroke length and bangs against the rear of the crank and bends the blade first stroke...i got a short stroke saw to try eventually. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now