its_masters Posted April 21, 2015 Share Posted April 21, 2015 I'm swapping parts from my 98 trans to my 97 trans (doing a drivetrain swap), and the clutch fork doesnt seem to want to stay in place. It seems like the clip slips off the pivot ball. I had this problem last time as well, the TOB would slide too far off the shaft. I was told to get an 06+ fork, but that involves a new fork, TOB, and pivot ball, and i dont really want to spend the money for that... Link to comment Share on other sites More sharing options...
Fairtax4me Posted April 21, 2015 Share Posted April 21, 2015 Is one hydraulic and the other cable actuated? The pivot position has to be moved depending on which it is. Link to comment Share on other sites More sharing options...
its_masters Posted April 21, 2015 Author Share Posted April 21, 2015 Is one hydraulic and the other cable actuated? The pivot position has to be moved depending on which it is. I will have to look, i believe it may have been a cable clutch. It didnt come with the fork so im not positive. How does one get the pivot ball out to move it? Link to comment Share on other sites More sharing options...
its_masters Posted April 21, 2015 Author Share Posted April 21, 2015 Cable clutch... So i just move the pivot ball? Link to comment Share on other sites More sharing options...
Fairtax4me Posted April 21, 2015 Share Posted April 21, 2015 Yes, just move the pivot to match the lever you need to use. There are two threaded holes in the case. You can tell pretty easy which lever needs to use which pivot mounting hole by looking at the distance from the end of the fork to the pivot hump on the lever. The pivot just unscrews. Should be 19mm IIRC. Link to comment Share on other sites More sharing options...
its_masters Posted April 22, 2015 Author Share Posted April 22, 2015 Yes, just move the pivot to match the lever you need to use. There are two threaded holes in the case. You can tell pretty easy which lever needs to use which pivot mounting hole by looking at the distance from the end of the fork to the pivot hump on the lever. The pivot just unscrews. Should be 19mm IIRC. Thank you! Got it done now! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now