beachbum Posted May 23, 2004 Share Posted May 23, 2004 hey guys a 1980 1.8 automatic, is there anything else that holds on the oil pump besides the 4 bolts? i have the crankshaft pulley off to replace the frt. oil seal and was going to replace the oil pump gasket while i was there. took off the for bolts and tapped it all around with a wooden mallet but it feels like something else is holding? thats my question of the day, thnx for any assistance. Link to comment Share on other sites More sharing options...
old sub freak Posted May 24, 2004 Share Posted May 24, 2004 the pump has a "plug" that fits into the block. just rock it up /down and GENTLY work it out. don't pry to hard it will break.they can be easy or!?#$^. take your time.it will come out.good luck,todd Link to comment Share on other sites More sharing options...
beachbum Posted May 24, 2004 Author Share Posted May 24, 2004 thnx tood ill try it,hope my prying earlier didnt do any damage:lol: Link to comment Share on other sites More sharing options...
old sub freak Posted May 24, 2004 Share Posted May 24, 2004 hey bb, i should have explaned more. you shouldn't pry between the "plate" and the block.{i learned the hard way} i use a small pry bar ,a block of wood[for a shim] and pry off the "horisontal cap bolt afair "[over flow valve?"]on the front of pump while pulling up/down on the oil filter. use wd40 ect and baby it off. i've even filed the "plug" to make it easyer to install.tape off holes in pump so no filings get in.its worth the work .the seals are usualy hard and break in your hand. as long as you didn't break off one of the "ears", clean up any nicks so it fits flush.and you could get by. good luck todd Link to comment Share on other sites More sharing options...
Sweet82 Posted May 24, 2004 Share Posted May 24, 2004 I broke my plate:mad: Becarefull Take your time!!!!!!!!!!!!!!!!!!!! Good luck! Link to comment Share on other sites More sharing options...
beachbum Posted May 25, 2004 Author Share Posted May 25, 2004 well i heard something go snap:-\ before i got u guys advice,wasnt sure if its because the prybar slipped or what,but i started it up and it registered and seem to run alright.now im waiting for the interchange advice i got posted,then ill retry,cause i`d like to have a backup just in case:lol: thnx again guys. Link to comment Share on other sites More sharing options...
Wrench Princess Posted May 25, 2004 Share Posted May 25, 2004 I have broken a plate on one too! It takes a lot of patience and finesse to get those suckers off without breaking them. Just take your time and your best bet is to try and tap it loose as much as possible because prying it is more likely to break it. When I broke one I wasn't even prying between the plate and the engine, I was just prying and the plate was so stuck on that it cracked in half (and I am a girl so obviously those things are fragile). Of course, I am exceptionally buff for a girl! Link to comment Share on other sites More sharing options...
beachbum Posted May 25, 2004 Author Share Posted May 25, 2004 thnx buff-princess ill keep all u guys and gals advice in mine as soon as i get a spare:brow: Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now