zombieblues Posted April 28, 2015 Share Posted April 28, 2015 Luckily I was going very slow! Not sure of the names for the problem parts yet haha. So the knuckle that is on the bottom part of the wheel assembly came out of the lower arm that connects it to the car. Pretty much dragged my tire under the car for 200 feet. Pictures will be up in a few hours after work. Hoping I can revive ole Michael J fox Link to comment Share on other sites More sharing options...
bratman18 Posted April 28, 2015 Share Posted April 28, 2015 Sounds like the ball joint failed. Link to comment Share on other sites More sharing options...
joe5 Posted April 28, 2015 Share Posted April 28, 2015 Sounds like the ball joint failed. wow this can happen from a ball joint failure? I've run mine into the ground pretty hard...glad I'm changing em now! 1 Link to comment Share on other sites More sharing options...
joe5 Posted April 28, 2015 Share Posted April 28, 2015 Like the ball joint would have to straight up snap in half? Link to comment Share on other sites More sharing options...
zombieblues Posted April 28, 2015 Author Share Posted April 28, 2015 It looks like the previous owner did work and either never put the bolt/pin on. or the little pin snapped and the bolt eventually fell off. I have not pulled the tire off or popped the hood to see what the damage is. I'm just praying its not horrible as I am a poor man. Link to comment Share on other sites More sharing options...
bratman18 Posted April 28, 2015 Share Posted April 28, 2015 When a ball joint gets old, the joint itself loosens up. And if it's bad enough, the joint can pop out of its socket. Or its possible the nut loosened up and popped out of the control arm too. Link to comment Share on other sites More sharing options...
Gloyale Posted April 28, 2015 Share Posted April 28, 2015 I've seen the pinch bolt come out or w/undersized bolt where ether joint falls out. Can be popped back in in this case and secure with correct pinchbolt Link to comment Share on other sites More sharing options...
wagonist Posted April 28, 2015 Share Posted April 28, 2015 I've had this happen to me also. Luckily I was only going about 40km/h (25MPH). Kind of could feel what happened & stomped on the brake pedal to lock up the wheels, causing the car to skid left. Problem was I was in a small country town, on the main street, which was due to be closed 15 mins later because of the annual parade... Link to comment Share on other sites More sharing options...
comatosellama Posted April 29, 2015 Share Posted April 29, 2015 When a ball joint gets old, the joint itself loosens up. And if it's bad enough, the joint can pop out of its socket. Or its possible the nut loosened up and popped out of the control arm too. That's happened to me. Ruined an axle 1 Link to comment Share on other sites More sharing options...
bratman18 Posted April 29, 2015 Share Posted April 29, 2015 I've never personally had it happen to me, but I scored a 92 fwd loyale sedan for 200 bucks because it happened to the previous owner. I swapped on a couple new parts and drove it home. Link to comment Share on other sites More sharing options...
zombieblues Posted April 29, 2015 Author Share Posted April 29, 2015 Alright so the full scoop!!! The idiot that replaced the ball joints (Lord knows how long ago!) Used a 20 gauge solid wire instead of the nice solid pin that should be in there. Fast forward a lot of rust..... The wire failed followed by the bolt falling off then inevitably the wheel assembly and tire. The quarter axle popped off the transmission along with the boot. CV seems like it may be fine if I replace the boot. Strut seems to be solid as well as strut mount. So if my check comes by Friday I will be replacing the ball joint, quarter axle boot, Struts and mounts and hopefully not the tye rods control arms or brakes. Sorry I didn't get any pictures while the wheel was under the car. My top priority was to spare any unnecessary damage. I can snap pictures of the progress while repairing and cleaning up the frame around the wheel wells if you all would like! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now